Field Controls 46448400 Manual 

Text of Field Controls 46448400 Manual 

*For best results, operate the UV-1500 continuously 24 hours a day.

UV-AIRE™ AIR PURIFYING SYSTEM Model: UV-1500C READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE PROCEEDING WITH THE INSTALLATION LEAVE THE INSTALLATION INSTRUCTIONS WITH THE OWNER/OPERATOR OF THE DEVICE AFTER OPENING THE CARTON, UNPACK AND INSPECT THE UNIT AND LAMP FOR DAMAGE. DO NOT

INDICATION FOR USE

This product is not sold as a medical device and is not for the purpose of diagnosis of any disease or condition nor for use in the mitigation, treatment, or prevention of any disease or condition. II. GENERAL INFORMATION Model Volts Amps Hz Watts Lamp Intensity at 1 meter Recommended Max Sq. Feet Weight Width (Inches) Height (In

FOR AREA OR ROOM OPERATION

1. Place the UV-1500C in the desired area; plug the power cord into a standard 120-volt wall receptacle. 2. Turn the speed control knob clockwise to turn on the unit and to adjust the motor/fan speed to the desired airflow. (See Figure 1) 3. After the fan has started, the LED light will show a continuous “GREEN” colo

3. Drill a 1/8” hole into the body of the UV-1500C at the marked locations. (See Figure 8)

4. Secure the extension covers the UV-1500C body with the supplied metal screws (See Figure 9 & 10). 5. Remove the two rubber feet on the side of the extension cover from bottom of unit to give necessary clearance for ceiling mount. (See Figure 11) 6. Before

11. Wire the UV-1500C in accordance with the National Electrical Code, manufacturer's recommendations and/or

applicable local codes. UNIT MUST BE GROUNDED. Check ground circuit to make certain that the unit has been properly grounded. The wiring should be protected by an over current circuit device rated at 15 amperes. Refer to Diagram A fo

5. Remove lamp carefully, by sliding the lamp to the left through the hole on the left side of the chamber. After

exposing the connection end of the lamp inside the chamber, remove the lamp through the front of the unit. NOTE: When replacing the lamp, always wipe off lamp with the supplied alcohol wipe after installing. 6. Replace the lamp by first g

Field Controls Other Owners Instructions: