Dell PowerVault 221S Manual
Text of the manual
w w w. d e l l . c o m | s u p p o r t . d e l l . c o m
Dell™ Systems
Rack-to-Tower Conversion
Guide
2H982bk1.book Page 3 Monday, November 5, 2001 10:12 AM
Notes, Notices, Cautions, and Warnings
NOTE: A NOTE indicates important information that helps you make better use of your computer.
NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you
how to avoid the problem.
CAUTION: A CAUTION indicates a potentially hazardous situation which, if not
avoided, may result in minor
Rack-to-Tower Conversion Guide
1-1
This conversion guide provides instructions for trained service technicians in removing
one or more Dell™ systems from a rack cabinet and converting the system to a tower (or
deskside) version. One rack-to-tower conversion kit is required for each system to be
converted from a rack version system to a tower version system
Rack-to-Tower Conversion Guide
w w w. d e l l . c o m | s u p p o r t . d e l l . c o m
•
Before working on the rack, make sure that the stabilizers are secured to the rack,
extend to the floor, and that the full weight of the rack rests on the floor. Install front
and side stabilizers on a single rack or front stabilizers for joined multiple racks b
Rack-to-Tower Conversion Guide
1-3
Figure 1-1.
Ra ck-t o-Towe r K it Contents
tower bezel, system badge
assembly, and keylock
¼-20 x 0.5-inch hex
socket-head screws (4)
tower front panel
round covers (2)
tower left and
right covers
¼ x 1 x 0.08-inch
washers (4)
base assembly
2H982bk1.book Page 3 Monday, November 5, 2001 10:12 AM
Rack-to-Tower Conversion Guide
w w w. d e l l . c o m | s u p p o r t . d e l l . c o m
Before You Begin
Before you begin removing your system from the rack and converting it to a tower system,
carefully read “Safety Instructions.”
Removing the Rack Doors
See the procedures for removing doors in the documentation provided with your rack
cabinet.
Re
Rack-to-Tower Conversion Guide
1-5
Removing the Rack Doors
You must remove the doors from the rack cabinet to provide access to the interior of the
rack and to prevent damage to the doors.
For Dell rack cabinets, see the documentation provided with the rack for instructions on
removing rack doors.
Removing the System From the Rack
CAUTION: If you are removi
Rack-to-Tower Conversion Guide
w w w. d e l l . c o m | s u p p o r t . d e l l . c o m
Figure 1-2.
Re moving the Sys tem Fr om t he Mounting Ra il A s semblies
Removing the Front Panel
This procedure is best performed with the front of the system extending 2.54 centimeters
(1 inch) beyond the edge of the work surface or table.
1
Label and remove the h
Rack-to-Tower Conversion Guide
1-7
Installing the Tower Front Panel
1
Position the tower front panel in place on the system chassis, using care to install the
five light pipes in their holes in the front panel.
NOTE: In the next step, start all 14 T-10 Torx screws in their holes before tightening any of the
screws to ensure proper alignment.
2
Install the t