TRENDnet TEW-434APB - 54Mbps Wireless G PoE Access Point Quick Installation Manual

Table of Contents Version 01.08.2007 English ...................................................................................................... Troubleshooting ........................................................................................ 1 1 2 3 5 8 1. Before You Start 2. Hardware Installation .......................... ...

A computer with a network adapter properly installed A network Switch or Hub with an available network LAN port A RJ-45 network cable Power over Ethernet Switch (Optional) TPE-101I (Optional) Package Contents 1. Before You Start English 1 TEW-434APB Quick Installation Guid ...

lights are on: WLAN and LAN. 2. Hardware Installation English 2 2. Connect the Power Adapter to the Access Point and then to a power outlet. Note: Locate an optimum location for the Access Point. The best place for the Access Point is usually at the center of your wireless network. Please connect the computer config ...

English 3 Using the TEW-434APB with a PoE switch 2. Verify that the following panel lights are on: WLAN and LAN. Please refer to step 3 in the Hardware Installation section. 1. Connect a RJ-45 cable from the Power-over-Ethernet Switch (e.g. TRENDnet TPE-S88) to the LAN port of the Access Point and then connect the 2dBi De ...

1. Connect the Power Cord to the AC Power Adapter. 2. Connect the AC Power Adapter to the DC 48V IN connector on the TPE-101I. Then connect the Power Cord to an outlet. 3. Connect a CAT-5 cable from a switch to the TPE-101I's DATA IN port. 4. Connect a CAT-5 cable from the TEW-434APB's LAN port to the TPE-101 ...

Note: It is recommended that you configure the Access Point from a wired computer. Before the Access Point can be configured, a Static IP address must be assigned to your computer's network adapter in the subnet of 192.168.1.x. Since the Access Point's default IP address is 192.168.1.100, make sure no other network ...

Access Point, verify the new password, and then click Next. (If a new password is not entered, the default password admin will be used. 4. Click Next. 6. Enter a SSID for your Access Point and then click Next. ...

7. Enable Encryption if needed and then click Next. 9. Click Close. Your installation is now complete. For detailed information regarding the TEW-434APB's configuration and advanced settings, please refer to the Troubleshooting section, User's Guide CD-ROM, or TRENDnet's website at http://www.trendnet.com. ...

1. Go into the Control Panel and double- click the Network Connections icon, right-click the Local Area Connection icon and then click Properties. 2. Click Internet Protocol (TCP/IP) and then click Properties. Then click on Use the following IP address, and make sure you assign your ...