Ford F–250 Operation & User’s Manual

19 Scheduled maintenance 32 Minor troubleshooting guide 33 Capacities and specifications 36 Service points 38 All rights reserved. Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage a ...

California Proposition 65 Warning: Diesel engine exhaust, some of its constituents, and certain vehicle components contain or may emit chemicals known to the State of California to cause cancer or birth defects or other reproductive harm. Your new diesel engine will feel, drive and function somewhat di ...

Your vehicle does not need an extensive break-in. Try not to drive continuously at the same speed for the first 1 600 km (1 000 miles) of new vehicle operation. Vary your speed to allow parts to adjust themselves to other parts. Drive your new vehicle at least 800 km (500 miles) before towing a trailer. Do not add friction modifier compo ...

The diesel engine fuel system consists of: • a frame-mounted electric fuel supply pump • an engine mounted fuel filter/water separator • a fuel restriction sensor • a unit injector for each cylinder The combination fuel filter/water separator removes both water and impurities from the fuel. The filter should be changed at th ...

The glow plug system consists of: • eight glow plugs • the glow plug relay • engine oil temperature (EOT) sensor • barometric pressure (BARO) sensor The glow plug system is electronically controlled by the PCM. The PCM energizes the glow plugs immediately after the ignition is placed in the ON position, then determines how ...

The restriction gauge, located on the clean-air side of the air cleaner upper housing, shows if the air filter is clogged. The air filter element should be replaced when the yellow band on the gauge reaches the CHANGE FILTER mark. Engine performance and fuel economy are adversely affected when maximum restriction is reached. Afte ...

70 80 90 100 20 km/h 40 60 80 100 120 140 H L 160 MPH 0 0 0 0 0 0 0 0 0 0 18 8 WAIT TO START WATER IN FUEL F H C E 0 0 0 0 0 0 0 0 0 0 MPH 20 km/h 40 60 80 100 120 140 160 0 10 20 30 40 50 60 70 80 90 100 WATER IN FUEL WAIT TO START FUEL RESET ABS L E F H RPM 1000 X 0 1 2 3 5 6 4 P R N 2 1 8 C 1 ...

With the key in the ON position, the WAIT TO START light will illuminate if glow plug heat is necessary as a starting aid. Wait until the light goes off before starting. The light should always illuminate briefly, when the ignition key is in the ON position. If the light does not illuminate, there may be a problem. Refer to the Starting chapter ...

Read all starting instructions carefully before you start your vehicle. Starting procedures are also shown on the vehicle visor. For temperatures below 0°C (32°F), the use of the correct grade engine oil is essential for proper operation. If your vehicle is equipped with a manual transmission, make sure the parking brake is set fully be ...

increase engine speed until the oil pressure gauge indicates normal pressure.) STOPPING THE ENGINE Turn the ignition to OFF. To prolong engine life (after extended high speed or maximum GVW operation), it is recommended that a hot engine be allowed to operate at low idle for about 7� ...