TRENDnet TEW-511BRP Operation & User’s Manual

Text of TRENDnet TEW-511BRP Operation & User’s Manual

No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any

means, whether electronic, mechanical, photocopying, recording, or otherwise without the prior writing of the publisher. March. 2005 Note: Due to European Wireless Regulations, Super A mode is not supported in EU version.

1. Introduction............................................................................................................... 3

2. Safety Notification .................................................................................................... 4 3. Hardware Installation................................................................................................ 5 4. How to Configuring the Dual Band Router..............

Thank you for purchasing your Wireless 802.11a+g AP Router.

This user guide will assist you with the installation procedure. The package you have received should contain the following items: ƒ TEW-511BRP Wireless 802.11a+g AP Router ƒ Quick Installation Guide ƒ User Manual CD-ROM ƒ Dual Diversity Detachable Antennas ƒ External Power Adapter (5V, 2.5A) ƒ RJ-45 Network Cable Note: if anything is missing, please contact

2. Safety Notification

Your Wireless AP Router should be placed in a safe and secure location. To ensure proper operation, please keep the unit away from water and other damaging elements. Please read the user manual thoroughly before you install the device. The device should only be repaired by authorized and qualified personnel. ƒ Please do not try to open or repair the device yourself. ƒ Do not place the device in a damp or humid loca

3. Hardware Installation

Front Panel The front panel provides LED’s for device status. Refer to the following table for the meaning of each feature. Power The Power LED lights up and will keep while the Router is powered on. When the Router goes through its self-diagnostic mode during every boot-up, this LED will flash. When the diagnostic is complete, the LED will be lit continuously. DMZ The DMZ LED indicates when the DMZ function is b

The rear panel features 4 LAN ports, 1 WAN port and Reset button. Refer to the following table for the meaning of each

feature. Internet LAN Power RESET RESET Button The RESET button can restore device to factory default settings by press this button for approx. 10 seconds during device power on status. Internet The Internet port is where you will connect your broadband Internet connection. LAN 1,2,3,4 These ports (1, 2, 3, 4) connect the Route

Hardware Installation for Connection to Your Broadband Modem

1. Power off your network devices. 2. Locate an optimum location for the Router. The best place for the Router is usually at the center of your wireless network, with line of sight to all of your wireless devices. 3. Adjust the antennas. Normally, the higher location of your Router will get better the performance. 4. Using a standard Ethernet network cable, connect the Router’s

4. How to Configuring the Dual Band Router

TURN ON POWER SUPPLY Quick power cycle would caused system corruption. When power on, be careful not to shut down in about 5 seconds, because data is writing to the flash. START UP & LOGIN In order to configure the Wireless 11ag Router, you must use web browser and manually input http://192.168.1.1 into the Address box and press Enter. The Main Page will appear. In order to configure the Wireless 11ag Router, you

TRENDnet Wireless Router Owners Instructions: