Tripp Lite SMART3000RMOD2U Owner's Manual

12 Battery Replacement 13 Storage 14 Service 14 Warranty 15 Warranty Registration 15 Owner’s Manual SmartPro® Rackmount Intelligent, Line-Interactive UPS System Model: SMART3000RMOD2U • 110/120/127V Sine Wave Input/Output • 3000 ...

The UPS is extremely heavy. Use caution when lifting and installing. • Install the UPS indoors, away from excess moisture or heat, direct sunlight, dust and conductive contaminants. • Install the UPS in a structurally sound area. • Only operate the UPS at indoor temperatures between 32° F and 104° F (between 0° C and 40° C). ...

is no manual bypass switch on the unit), the UPS automatically switches to “BYPASS” mode. This allows the power module to be removed for mainte- nance, repair or replacement without disrup ...

retention bracket for access. Check to ensure that the external battery pack you are connecting matches the voltage listed next to the battery connector. Refer to the battery pack owner’s ...

screws and wing nuts A . Leave the screws slightly loose so that the shelves can be adjusted in the next step. 2 Adjust each shelf to fit the rack, then mount them in the lowest available space of the rack with the screws, nuts and washers provided B . N ...

10 in. (254 mm) 1 2 3 1 Adjust each stand to a width of 3.50 inches (89 mm) to match the UPS. Align the stands approximately 10 inches (254 mm) apart. 2 Have one or more assistants help you place the UPS on its side in the stands. Place the UPS so that its control panel is on top and facing outward. 3 Rotate the control panel for ...

dedicated circuit. NOTE: After you plug the UPS into a live AC outlet, the UPS will automatically charge its batteries* and will supply power to its outlets unless the unit is turned OFF (see Step 3 below). 2 Plug your equipment into the UPS.* * Your UPS is designed to support only electronic equipment. Yo ...

Use the included USB cable 1a and/or RS-232 DB9 serial cable 1b to connect the communication port of a computer to the communication port of the UPS. Install the PowerAlert software appropriate for the computer’s operating system. Consult the PowerAlert manual for more information. 2  ...

“ON” Button To turn the UPS ON: • with the UPS plugged into a live AC wall outlet, press and hold the “ON” button for one second. Release the button after you hear a beep. If utility power is absent, you can “cold-start” the UPS (i.e.: turn it ON and supply power for a limited time from its batteries, if they� ...

Sample LED Displays ”Load/Battery” Bar Graph: The LED bars indicate the level of the output load and battery capacity. 100% Load/Battery Bar LED Load Bar graph: 81%-105% load (Yellow) Battery Bar Graph: 81%-100% battery capacity (Green) 80% Load/Battery Bar LED Load Bar graph: 61%-85% load (Gr ...