Troy-Bilt 7524 Operator's Manual

Text of the manual

7524 & 8526

IMPORTANT: Read safety rules and instructions carefully before operating equipment. Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest- covered, brush-covered or grass-covered Iand unless the engine's exhaust system is equ

Important Safe Operation Practices ...................................................................................

3 Assembling Your Snow Thrower ........................................................................................ 5 Know Your Snow Thrower ...................................................................

This symbol points out important safety instructions

which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal i

7. Mufflerandenginebecomehotand can cause a burn. Do

not touch. 8. Exercise extreme caution when operating on or crossing gravel surfaces. Stay alert for hidden hazards or traffic.

Remove staples from the top, sides, and ends of

the shipping crate. Set panels aside to avoid tire punctures or personal injury. Remove and discard plastic bag that covers unit. Roll the unit out of the crate. Check the crate for loose parts before discarding. LooseParts The augers are secured to the auger shaft

NOTE: If the tire pressure

is not equal in all tires, the unit may pull to one side or the other. Figure 3 ConnectingAlternatorLead (Model 8526 Only) Unwrap the headlight wire which is attached to the headlight, beneath the handle panel. Wind the headlight wire around the lower right handle until excess slack is removed. See Figure 4. Plug the wi

IMPORTANT:If theaugershowsanysignsofrotating, immediatelyreturntotheoperator'spositionandshut offtheengine.Waitforallmovingpartstostopbefore readjustingtheaugercontrolcable. Toreadjustthecontrolcable,loosenthehexjam nutontheaugercontrolcable"Z"fitting. Rotatethecouplingendofthecable counterclockwise toprovidemoreslack. Retightenthehexjamnut.SeeFigure5. Repea

The auger control is located on the left

handle. Squeeze the auger control to engage the augers; release to disengage. Traction control must also be released in order to stop the auger. Shift Lever The shift lever is located in the center of the handle panel and is used to determin

Other Snow Blower Manuals