Fujitsu Lifebook E8010 Bios Manual
Text of Fujitsu Lifebook E8010 Bios Manual
LifeBook E Series Models:
E8010
Document Date: 06/09/04
Document Part Number: FPC58-1150-01
F U J I T S U C O M P U T E R S Y S T E M S
L i f e B o o k E S e r i e s B I O S
E Series BIOS
BIOS SETUP UTILITY
The BIOS Setup Utility is a program that sets up the
operating environment for your notebook. Your BIOS
is set at the factory for normal operating conditions,
therefore there is no need to set or change the BIOS
environment to operate your notebook.
The BIOS Setup Utility configures:
■Device control feature parameters, such as changing
I/O addresses and boot devices.
■System Da
3. If an error message is displayed on the screen, and
you want to enter the setup utility, press the [F2] key.
4. When the setup utility starts with a fault present, the
system displays the following message:
Warning!
Error message
[Continue]
5. Press any key to enter the setup utility. The system
will then display the Main Menu with current
parameters values.
M a i n M e n u
L i f e B o o k E S e r i e s B I O S MAIN MENU – SETTING STANDARD SYSTEM PARAMETERS
The Main Menu allows you to set or view the current
system parameters. (See Navigating through the Setup
Utility on page 2 for more information.)
The following tables show the names of the menu fields
for the Main menu and its submenus, all of the options
for each field, the default settings and a description of
the field’s function and any special information nee
number of the hard
drive.
Display the type of device on this ATA/ATAPI interface, if there is
one. Pressing the Enter key selects the Primary Master submenu
allowing additional device configuration options for this interface.
Secondary Master
■Selects Secondary
Master submenu
The product num-
ber of the
CD-ROM drive.
Display the type of device on this ATA/ATAPI interface, if there is
one. Pr
L i f e B o o k E S e r i e s B I O S Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA devices are installed.
Figure 2. Primary Master Submenu
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field
Options
Default
Description
Type:
■Auto
■None
■CD-ROM
■Hard Disk
[Auto]
Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the
■A number between
1 and 16
–—
This item is active only when Hard Disk is selected as type. You can
change the value by incrementing (pressing the [Spacebar]) or by
typing in the number.
Sectors:
■A number between
0 and 63
–—
This item is active only when Hard Disk is selected as type. You can
change the value by incrementing (pressing the [Spacebar]) or by
typing in the number.
Maximum
Capacity:
■Display only
–—
Displays the maxi
L i f e B o o k E S e r i e s B I O S Secondary Master Submenu of the Main Menu
The Secondary Master submenu allows you to configure secondary ATA devices.
Figure 3. Secondary Master Submenu
Table 3: Fields, Options and Defaults for the Secondary Master Submenu of the Main Menu
Menu Field
Options
Default
Description
Type:
■Auto
■None
■CD-ROM
■Hard Disk
[Auto]
NOTE: The Type field does not appear as a drop-down menu. Tap
the spacebar to cycle