Uniden BCT10 Operating Manual

Text of the manual

Congratulations on your purchase of the BCT-10 Highway

Information System & Scanning Radio! State-of-the-art engineering and advanced electronics provide you with a preprogrammed information radio designed for easy operation and dependability. With the BCT-10 Scanning Radio, you can listen to hundreds of highway patrol and police frequen

Terms and Definitions

Frequency Radio signals are sent as waves through the air. These waves move up and down. A frequency is the number of times in a certain time period, usually a second, that these waves move all the way up and all the way down and back to all the way up. For example: 123.44 kHz means that the waves are moving all the way up and all the w

Carefully remove all items from the box. If there is any visible

damage, do not operate the equipment. Notify your dealer or shipping carrier immediately. For information or instructions on any problem that you may have, call the Uniden Customer Service Center at: (800) 297-1023 Monday through Friday, 8:00 a.m. to 5:00 p.m. Central. 3

Included with Your BCT-10 Scanner

If any of these items are missing, please contact your place of purchase. OFF MUTE MODE ALARM L/0 HOLD STATE HIGHWAY SYSTEM The BCT-10 Highway Information System Windshield Mounting Bracket and Hardware Visor Clip Mounting Bracket BCT-10 Antenna Cigarette Adapter Power Cord BCT 10 SCANNER Operating Guide HOLD L/0 STATE MUTE

The BCT-10 uses a highly sensitive antenna to receive radio

signals. Its sensitivity and range depend on the method of installation and the direction of the antenna in relation to the signal source. Before you decide where to put your scanner, please keep in mind one important factor: For safety, do not mount the BCT-10 in a location where it wi

Installing the Antenna

BCT-10 Antenna 1. Pinch the sides of the antenna and attach it to the BCT-10. Flexible Mobile Antenna 1. Mount the antenna on the inside of the windshield at the far right-hand (passenger) side. Caution: Be sure the antenna does not obstruct the driver’s vision in any way. 2. Route the antenna cable down the edge of the windshield an

Caution: Be sure the cable is out of the way of anyone getting in or

out of the car. 3. Plug the cable’s BNC connector into the BCT-10. Mounting the BCT-10 Visor Mounting 1. Snap the visor clip onto the BCT-10. Note: Make sure that the bracket tabs fit securely in the slots. HOLD L/0 STATE MUTE MODE ALARM HIGHWAY SYSTEM SQUELCH Slots Installation 7

Slide the clip over the front

of the visor. 3. Adjust the angle of the antenna as close to straight up or down as possible. Note: You can remove and replace the BCT-10 by sliding both the unit and the visor mount off and on the visor. SQUELCH SQUELCH Installation 8

Find a good position for the BCT-10 on your windshield. Refer

to the Helpful Tips on page 5 for some guidelines on mounting positions. 2. Put the metal mounting bracket on the windshield to adjust it for best position. 3. If necessary, adjust the metal mounting bracket so that when you slide the BCT-10 onto it, it is parallel to the ro

Other Scanner Manuals