Fujitsu Modular Floppy Disk Drive Installation And User Manual
Text of the manual
This guide contains information on installing,
removing, and using your Modular Floppy Disk
Drive with your Fujitsu computer.
We recommend that you read this document
before using the floppy disk drive, even if you are
already familiar with portable computers and
accessories.
I N S T R U C T I O N S
Modular Floppy Disk Drive
Installation and User’s Guide
F
Your modular floppy disk drive installs in the system’s
Flexible Bay.
The proper connection of your modular floppy disk drive is
determined by the computer’s power state when you connect
the floppy disk drive (system suspended, running, or off).
In the following steps, the floppy disk drive is referred to as a
“modular device” or “Flexible Bay de
To cold-swap modular devices in your Flexible Bay follow
these easy steps: (Figure 1)
1. Close any open files.
2. Shut down your LifeBook notebook.
3. Pull out the Flexible Bay eject lever. This will push your
device out slightly, allowing you to remove the device.
4. Slide your device out until it is clear of the bay. This will
require light
5. Slide the device you are installing into your notebook
until it clicks into place.
6. It is now safe to turn your notebook back on.
7. You can now access and use the device.
Your LifeBook notebook will automatically detect the new
device and activate it within your system. The drive letters
associated with the device will be created and listed under
My
Loading a Disk
To load a disk into your disk drive, follow these steps:
1. Orient the disk so that its label is facing upwards and the
shutter side is pointing towards the drive (see Figure 2).
Figure 2. Loading/Ejecting a 3.5” Floppy Disk
2. Push the disk into the drive until the Eject button pops
out and you hear a click.
Ejecting a Disk
To eject a dis
2. Press the Eject button. This will push your disk partially
out of the drive.
3. Remove the disk.
Preparing a Disk for Use
Before you can use a new disk, it needs to be prepared so your
computer knows where to store information. This prepara-
tion is called formatting or initializing a disk. You will need to
format new disks, unless they are pre-formatte
Figure 4. Floppy Disk Write Protected
Formatting a floppy disk that already con-
tains data will erase all of the information on
the disk.
Write Protected
Write Enabled
Rear View
of Disk
Fujitsu Computer Systems Corporation
1250 E. Arques Avenue (M/S 122),
Sunnyvale, California 94085
For more information, call
1-877-372-3473 or visit our Web site at:
us.fujitsu.com/computers
For technical support call:
1-800-8Fujitsu (1-800-838-5487)
or e-mail us at: [email protected]
Fujitsu and the Fujitsu logo are registered trademarks of Fujitsu,