Garmin c340 Quick Reference Manual

Press and hold the Power button on the side of the unit to turn it on. Follow the on-screen instructions to set up your c340; you only have to do this once. Step 3: Find Your Destination Touch Where to? Touch . Enjoy the route! Select a destination. Touch the arrows to see more places. Select a category. Touch the arrows to see more categories. Step 1: Mount Your c340 To ensure a tight grip, clean and dry your windshield before mounting the suction cup. 1 Fit the bottom of your c340 into the cradle of the suction cup mount. Tilt your c340 back until it snaps in place. Place the suction cup on the windshield. Flip the lever back, toward the windshield. Plug the small end of the cable into the mount and the other end in a 12-Volt receptacle in your vehicle. Tension knob 2 1 2 3 If necessary, use the tension knob to loosen or tighten the tension in the mount to improve your viewing angle. Your unit will turn on automatically if you have started your vehicle. To manually turn on your c340, press and hold the Power button on the side of the unit. WARNING: For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the c340 installed to place and secure the device so it will not interfere with the vehicle operating controls and safety devices, obstruct the driver’s view of driving conditions, or cause personal injury in the event of an accident. NOTICE TO STATE OF CALIFORNIA DRIVERS: California Vehicle Code Section 26708 (a) (1) provides that drivers in California should not use suction mounts on their windshield or side or rear windows. Other Garmin dashboard or friction mounting options should be used. For available accessories, refer to the Garmin Web site at www.garmin.com. Also, refer to the Owner’s Manual for instructions on using the included mounting disk with the suction cup mount. Step 4: Follow Your Route Follow the route to your destination using the Map page. As you travel, your c340 guides you to your destination with voice prompts, arrows on the map, and directions at the top of the Map page. If you depart from the original route, your c340 recalculates the route and provides new route instructions. A checkered flag marks your destination. Follow the arrows as you take turns. Your route is marked with a magenta line. You can add a stop (via point) to your route. The c340 gives you directions to the via point and then to your final destination. Touch an option. Touch . Search for the extra stop. StreetPilot ® c340 quick reference guide © Copyright 2005 Garmin Ltd. or its subsidiaries August 2005 190-00437-01 Rev. B Printed in Taiwan

Adjusting the Volume To adjust the volume, turn the Volume knob, located above the Power button. Turning the c340 On and Off Press and hold the Power button on the side of the unit to turn it on and off. More Information For more information about your c340, refer to the Owner’s Manual located at http://www.garmin.com/products/sp340/. Click on the Manuals link and then select Download. Saving Places You Find After you have found a place, touch Save. Touch OK in the pop-up window. The place is saved in My Locations > Favorites. Finding Saved Places Touch . Touch Where to? > My Locations > Favorites. Select a place. Setting a Home Location Select an option. Touch Where to? > My Locations. Touch Set Home. Traffic Information with an FM TMC Traffic Receiver Using a Garmin FM TMC Traffic Receiver, your c340 can receive and use traffic information broadcast over the FM Radio Data System. For more information about the GTM 10 FM TMC Traffic Receiver, visit http://www.garmin.com/products/ gtm10. For subscription providers, visit http://www.garmin.com/fmtraffic. Connecting the GTM 10 to Your c340 Place your c340 in the mount and plug it into the 12-volt adapter. Plug the USB cable from the GTM 10 into the USB cable connector on the side of the c340. Viewing Traffic Events From the Menu page, touch to display a list of traffic events. The traffic symbols appear on the Map as well. Viewing the Map Page From the Menu page, touch View map to open the Map page. The position icon shows your current location. Touch the buttons on the Map page to see additional information. Map Page while Navigating a Route Touch Arrival or Speed to open the Trip Information page. Touch Turn In to open the Next Turn page. Touch the text bar to open the Current Route page. Touch to zoom out. Touch to zoom in. Touch Menu to return to the Menu page. Next Turn Page Current Route Page Trip Information Page Volume knob Power button USB cable connector