Garmin 22 Installation Instructions Manual

Text of the manual

All rights reserved. Except as expressly provided herein, no part of this manual may be reproduced, copied, transmitted, disseminated, downloaded, or stored in any

storage medium, for any purpose without the express prior written consent of Garmin. Garmin hereby grants permission to download a single copy of this manual onto a hard drive or other electronic

GSD 22 Sonar Module

INTRODUCTION Thank you for choosing the Garmin GSD 22 Sounder Module. The GSD 22 is a CANetTM and Garmin Marine Network compatible, remote sounder module designed to include powerful features found in other Garmin sounders, including Color Depth Control Gain (DCG®), DynacolorTM, and auto gain features technology. When used with compati

GSD 22 Sonar Module

INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS The GSD 22 must be properly installed according to the following CANet or Marine Network installation instructions to get the best possible performance. Refer to your chartplotter to determine the correct installation method. To complete the installation, you need appropriate fasteners

GSD 22 Sonar Module

INSTALLATION INSTRUCTIONS CANet Wiring for the Garmin GSD 22 Notes: 1. Power and ground wires require 18 AWG. You can extend the CANet wiring of the GSD 22 power/data cable up to 80 ft (24.38 m) total length using the CANet Connections Kit. 2. The CANet Extension Cable can support a maximum of two display units and one sonar unit. 3. Th

GSD 22 Sonar Module

INSTALLATION INSTRUCTIONS Marine Network Wiring and Cables Garmin Marine Network components use specialized Garmin Network cables. For some installations, it may be necessary to drill 1.25" (31.7 mm) holes to route the connector end of the cables. Garmin rubber grommets are provided to cover the installation holes (see below). Wiring in

GSD 22 Sonar Module

INSTALLATION INSTRUCTIONS The following diagrams shows the Garmin Marine Network with a GSD 22 Sounder Module connected. GARMIN GDL 30/30A MARINE WEATHER/AUDIO SATELLITE RECEIVER GPS 17 GARMIN GMS 10 MARINE NETWORK PORT EXPANDER GSD 22 SOUNDER MODULE GARMIN MARINE RADAR TO TRANSDUCER xxxxxxx x x x x xxxxxxxxxx Serial cable Ethernet cab

GSD 22 Sonar Module

INSTALLATION INSTRUCTIONS Blink Codes When the unit is installed, it switches on when the display unit is powered on (or the GSD 22 remote power line is pulled low, with power applied). The two-color (Green/Red) LED on the GSD 22 indicates the current operational status of the module. Codes are: Code Status Green blinking, on for 1 seco

Other Other Manuals