Rane MA 6s Operator's Manual
Text of the manual
You gots your good habits, and you gots your bad habits. A good habit is to read at least this much of the manual. A bad
habit is not to read any of this manual. Reading just this section can prevent grief worse than your worst nightmare. Grief
that's hard to get rid of—harder than a bad h
FRONT PANEL DESCRIPTION
POWER switch: Obediently turns the MA 6S on and off every time you poke it with your finger (or other suitable object).
All six channels have delayed turn-on/instant turn-off relays to eliminate any switching transients.
THERMAL Overload indicator: Lights red if the MA 6S becomes too hot, indicating that power has been re
REAR PANEL DESCRIPTION
INPUTS: These are balanced Euroblock connectors. Cable should include two wires with shield. Euroblocks accept up to
12 AWG wire. The shield may be attached to either chassis or signal ground. For unbalanced sources consult the included
RaneNote, “Sound System Interconnection.”
OUTPUTS: Connect the speaker(s) to each o
MA 6S CONNECTIONS
Direct, Biamp, and Bridged Wiring
MA 6S
ACN 001 345 482
MADE IN U.S.A.
RANE CORP.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK DO
NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. DO
NOT REMOVE COVER. NO USER SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
AVIS
RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
CA
The MA 6S will drive an active two-way stereo system when wired as shown. The high frequency drivers run direct from
channels 5 and 6. The low frequency drivers, requiring much more power, are run from two bridged pairs: Channels 1 and 2
are bridged to one woofer, and channels 3 and 4 are bridged to the second woofer.
CAUTION: 8 ohms is the lowest i
