Numark SA3000 Owner's Manual
Text of the manual
©1997 Numark Industries
http://www.numark.com
3
SAFETY FIRST!
WARNING - TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
WATER AND ELECTRICITY DO NOT MIX. Keep this unit away from water. If water or other liquids are
spilled on or into this unit, unplug the power cord immediately from the wall socket (with DRY
©1997 Numark Industries
http://www.numark.com
5
Contents
Warning and Safety Instructions
3
Introduction
6
Front-Panel Description
7
Back-Panel Description
8
Audio Terms
10
Hook-up #1: Home Studio Reference Amp
12
Hook-up #2: Mobile DJ Stereo PA
12
Hook-up #3: Monitor Amplifier
13
Hook-up #4: Stereo PA System
13
Specifications
14
Block Diagram
15
Warranty an
©1997 Numark Industries
http://www.numark.com
6
Introduction
Thank you for choosing a Performance Series power
amplifier from Numark. These units are designed to
provide a good combination of power, audio clarity,
and reliable operation. The basic circuit has been
kept as simple as possible to reduce the amount of
components, thereby shortening the signal p
©1997 Numark Industries
http://www.numark.com
7
Front Panel Description
1. Gain Controls
These two knobs are the level controls for each channel
of the amplifier. The gain increases as the knob is turned
clockwise. The SA5500 features detented gain controls
with dB calibrations to simplify set up.
2. Limit LED
If an audio signal is amplified beyond the l
©1997 Numark Industries
http://www.numark.com
8
Back Panel Description
6. Neutrick Connector Inputs
a. Balanced XLR Inputs
These combined inputs are commonly used for both
mobile and installation set ups. The XLR provide a good
combination of ease of connection and resistance to
corrosion. They are wired as per the following
convention:
b. Balanced 1/4”
©1997 Numark Industries
http://www.numark.com
9
3. ensure that there is only one input signal connected
to channel 1 of the amplifier - channel 2 input must be
vacant
4. switch the amplifier to bridged mono (back panel
switch)
5. turn the gain down and turn on the amp
6. verify operation at low gain, and then increase power
to desired level, ensuring that t