Raypak B0109 Owner's Manual And Installation Instructions

Text of the manual

Raypak Water Heaters

Models Types B0109 NCO, NCH PCO, PCH B0147 This water heater must be installed and serviced by an authorised person. Please leave this guide with the householder or responsible officer.

Notice to Victorian Customers from the

Victorian Plumbing Industry Commission This water heater must be installed by a licensed person as required by The Victorian Building Act 1993 Only a licensed person will give you a Compliance Certificate, showing that the work complies with all the relevant standards. Only a licensed person will have insurance protecti

HOUSEHOLDER OR RESPONSIBLE OFFICER – We recommend you read pages 4 to 11.

The other pages are intended for the installer but may be of interest CONTENTS .................................................................................................................................................................. 3 ABOUT YOUR WATER HEATER .....

ABOUT YOUR WATER HEATER

MODEL TYPE Congratulations for choosing a Raypak® water heater. The model you have chosen is suitable for either indoor or outdoor installation depending on use of the appropriate installation kit. The operation of the water heater depends on the application. Typically for hot water applications a water heater with ‘on/off’ ope

ABOUT YOUR WATER HEATER

5 SAFETY For your safety do not operate this water heater before reading this instruction booklet. This water heater is supplied with a thermostat, hi-limit thermostat and a pressure relief valve. These devices must not be tampered with or removed. The water heater must not be operated unless each of these devices is fitted and is in

ABOUT YOUR WATER HEATER

6 TO TURN ON THE WATER HEATER WARNING! If you smell gas do not attempt to turn on the water heater. • Fill the system with water (refer to “To Fill the Water Heater” on page 32) • Open the gas isolation valve fully at the inlet to the water heater. • Plug in the power supply cord at the power outlet. • Switch on the elect

HOW YOUR WATER HEATER WORKS

The water heater consists of a gas burner, a combustion chamber lined with refractory tiles and a heat-exchanger made of finned copper tubes. Hot flue gases from the burner pass between the fins on the heat exchanger tubes and heat is transferred first to the fins and then by conduction into the water. Baffles are placed between

HOW YOUR WATER HEATER WORKS

8 147 MODELS On/Off Operation 147 On/Off models are fitted with an electronic thermostat that operates the gas control by switching its power on and off, so a constant temperature is maintained. The thermostat is mounted on the control panel of the water heater and the protective over temperature cut out is mounted inside the lowe

Other Water Heater Manuals