DigiTech RPX USB - Software Installation Manual

contains the information to install the required USB drivers, X-Edit editor/librarian and Pro Tracks recording software for use with the RPx400. Please follow these instructions carefully to ensure smooth installation of each of these components. A. Installing Pro Tracks 1. Start ...

click on Browse, type d:\instmenu.exe (where d:\ is your CD-ROM drive), and click OK. 7. Now select USB Audio MIDI Drivers from the menu. You will see the following window appear: 8. Click Next. Installation of the drivers could take several minutes. NOTE: If you don’t hav ...

14. Click Finish. The RPx400 USB driver installation is now complete. Windows 2000 Users NOTE: DO NOT connect the RPx400 to your Windows 2000 computer until AFTER the DigiTech USB drivers are installed or it may cause instability in Windows. 1. Make sure you DO NOT have the RPx400 USB plugged into your computer. 2. ...

you will see: 6. Click Finish. 7. Connect the RPx400 to the computer with the included USB cable. The following window will appear: 8. Click Yes and you will see: ...

10. You DO NOT need to restart your computer yet. Click No and you will see: 11. Click Yes and you will see: ...

13. You DO NOT need to restart your computer yet. Click No and you will see: 14. Click Yes and you will see: ...

16. Click No. Repeat steps 14 and 15 once more. Then you will see: 17. This time click Yes and your computer will restart. The RPx400 USB driver installation is now complete. C. Setup Windows Audio and MIDI When we installed the DigiTech USB Audio and MIDI drivers,Windows may have automatically selected them as your default ...

we will change the settings in Pro Tracks to use the RPx400 for audio and MIDI. At this point you are ready to use the RPx400 to record with Pro Tracks. You can continue to the next section to install the X-Edit/Librarian. If you are anxious to record, skip the Setting Up th ...