Sharp AR-405 Operation Manual

• MAKING COPIES • SPECIAL FUNCTIONS • SUPPLIES • COPIER TROUBLE? • GENERAL INFORMATION • OPTIONAL EQUIPMENT • KEY OPERATOR’S GUIDE 1-1 2-1 3-1 4-1 5-1 6-1 7-1 8-1 DIGITAL COPYING MACHINE OPERATION MANUAL Page MODEL AR-405 ...

instead of "ON" and "OFF". The symbol " " denotes the copier is not completely de-energized but in a stand-by condition at this "POWER" switch position. If your copier is so marked, please read "I" for "ON" and " " for "OFF". Caution! For a complete electrical disconnect ...

Types and sizes of copy paper ......... 4-2 Loading copy paper ................. 4-2 G ADDING TONER ................... 4-5 G USED TONER DISPOSAL ............ 4-7 G STORAGE OF SUPPLIES ............ 4-8 CHAPTER 5 COPIER TROUBLE? G MISFEED REMOVAL................ 5-2 G MAINTENANCE REQUIRED ......... 5 ...

including intelligent image-editing functions. Amongst its many useful features and functions are the document feeder, various special functions such as ...

Page G GG GG INSTALLATION REQUIREMENTS ..................... 1-2 G GG GG CAUTIONS ...................................... 1-3 G GG GG POWER ON AND OFF .............................. 1-5 Power save modes ......... ...

before initial installation and whenever the machine is to be relocated. 1. The copier should be installed near an accessible power outlet for easy connection. 2. Be sure to connect the power cord only to a power outlet that meets the specified v ...

smudges on the drum will cause dirty copies. 2. The fusing unit is extremely hot. Exercise care in this area. 3. Since a hard disk drive is built into the copier, be sure to turn the power switch to the “OFF” position when moving the copier. Take care not to subject the copier ...

AVOID EXPOSURE TO BEAM. Laserstrahl UNSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNET UND SICHERHEITSVERRIEGELUNG ÜBERERÜCKT. NICHT DEM STRAHL AUSSETZEN. USYNLIG LASERSTRÅLING VED ÅBNING, NÅR SIKKERHEDSAFBRYDERE ER UDE AF FUNKTION ...

The power switch is located on the left side of the copier. When the power switch is turned to the “ON” position, the message “WARMING UP. PLEASE WAIT.” will appear in the message display. Warming up takes about 65 seconds. Once the copier is ready, the message display will change to “READY TO COPY.”, and the START ...

Auto power shut-off mode If the auto power shut-off mode is enabled, the copier will automatically turn off the power once a programmed length of time has elapsed without any copier operation after the last copy of a run is made or the power is first turned on. The power switch will automatically be turned to th ...