Sharp R-1512 Installation Instructions Manual

Text of Sharp R-1512 Installation Instructions Manual

To aid in reporting this microwave oven in case of loss or theft, please record below the model number and serial

number located on the unit. We also suggest you record all the information listed and retain for future reference. MODEL NUMBER ________________________ SERIAL NUMBER ______________ DATE OF PURCHASE ______________________ DEALER ____________________________ TELEPHONE ________________ SERVICER ___________________________ TELEPHONE ____________

C O N T E N T S

For Customer Assistance.......................... 2 Precautions to Avoid Possible Exposure to Excessive Microwave Energy .................................. 2 Contents...................................................... 3 Consumer Limited Warranty ..................... 4 Product Information Card.......................... 4 Important Safety Instructions ................... 5 Unpacking and Installation Instructions . 6-14 Unpacking and Exa

SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand

product (the “Product”), when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective Product or part thereof with a new or remanufactured equivalent at no charge to the purchaser for parts or labor for the period(s) set forth below. Th

Sharp R-1512 I M P O R TA N T S A F E T Y I N S T R U C T I O N S

SAVE THESE INSTRUCTIONS When using electrical appliances basic safety precautions should be followed, including the following: WARNING - To reduce the risk of burns, electric shock, fire, injury to persons or exposure to excessive microwave energy: 1. READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE. 2. Read and follow the specific “PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENER

Open the bottom of the carton, bend the carton flaps back and tilt the oven

over to rest on plasticfoam pad. Lift carton off oven and remove all packing materials, WALL and TOP CABINET TEMPLATE, Turntable, and Turntable Support. SAVE THE CARTON AS IT MAY MAKE INSTALLATION EASIER. 1. Remove the feature sticker from the outside of the door, if there is one. 2. DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the right side wall of the oven cavity. C

U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S

Ground Receptacle Opening for Power Cord 4 HOOD EXHAUST DUCT When the hood is vented to the outside, a hood exhaust duct is required. All ductwork must be metal; absolutely do not use plastic duct. Check that all connections are made securely. Please read the following carefully: Exhaust connection: The hood exhaust has been designed to connect to a standard 3-1/4” X 1
U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S • Phillips Screwdriver • Electric Drill • 1/2”, 5/8” and 3/32” Drill Bits • 1-1/2” Wood Bit or Metal Hole Cutter (if metal cabinet is used) • Saw to cut exhaust opening (if needed) • Protective Drop Cloth for product and range - you may also use carton for protection • Scissors • Pencil • Measure • Tape Figure 4 Parts shown not to common scale. ITEM NAM
U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S 1. Turn oven on the side. See Figure 5. 2. Follow steps (A)-(D) to remove mounting plate from the back of the oven as shown in Figure 5. (A) Release mounting plate by pulling out the lever that is on the bottom of the oven. See Figure 6. (B) When lever is out, pull that side of the mounting plate away from the oven. See Figure 5. (C) Repeat step (A) on other side. (D) Repeat step

Sharp R-1512 8 VENTILATION SYSTEM (PREPARING OVEN FOR INSTALLATION)

This Microwave Oven/Hood is designed for adaptation to three types of hood ventilation systems. Select the type required for your installation. Recirculating — non-vented, ductless. Follow installation procedure (A). Recirculating requires the use of the Charcoal Filter, which has already been installed in the oven. Horizontal Exhaust — outside ventilation. Follow installation procedure (B). Ve
U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S (C) VERTICAL EXHAUST: OUTSIDE VENTILATION 1. Remove and save 2 screws from back edge and 3 screws from the top center of the Fan Cover Bracket. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket as shown in Figure 11. 2. Lift Hood Fan Unit carefully and slip wires out of cavity. See Figure 12. CAUTION: Do not pull or stretch hoo
U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S 9 OVEN INSTALLATION THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUC- TIONS FOUND ON WALL AND TOP CABINET TEMPLATES. THE NEXT STEP IS TO READ AND FOLLOW MOUNTING INFORMATION ON WALL AND TOP CABINET TEMPLATES. THIS OVEN MUST BE ATTACHED TO AT LEAST ONE WALL STUD. SEE WALL CONSTRUC- TION ON PAGE 6. WHEN DONE WITH TEMPLATES, PROCEED TO MOUNTING SCALE
U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S Top Side Cutting Line Figure 21 (A) (B) Figure 20 Figure 22 10 PREPARATION AND USE OF THE CARTON TO ASSIST IN THE INSTALLATION OF THE MICROWAVE OVEN Utilization of the carton may make installation easier. 1. Place carton upside down. See Figure 20. 2. Using cutting line around the carton, cut into two pieces (A) and (B). See Figure 21. 3. Position oven to assist in mounting to th

Two optional accessories are available for this oven.

1. Charcoal Filter (RK-240). This is required when hood exhaust is recirculated. See Charcoal Filter on page 33. If dealer does not stock this item, it can be ordered by calling 1-800-642-2122. 2. Filler Panel Kit. For use when the oven is installed in a 36-inch or 42-inch wide opening. The metal filler panels come in 3-inch wide pairs. One set is needed for a 36-inch opening and 2 sets for a 42-inc

I N F O R M AT I O N Y O U N E E D T O K N O W

ABOUT YOUR OVEN Eggs, sausages, nuts, seeds, fruits & vegetables Popcorn Baby food General ABOUT FOOD • Puncture egg yolks before cooking to prevent “explosion”. • Pierce skins of potatoes, apples, squash, hot dogs and sausages so that steam escapes. • Use specially bagged popcorn for the microwave oven. • Listen while popping corn for the popping to slow to 1 or 2 seconds or use special POP

ABOUT UTENSILS AND COVERINGS

becomes very hot should not be used. The following coverings are ideal: • Paper towels are good for covering foods for re- heating and absorbing fat while cooking bacon. • Wax paper can be used for cooking and reheating. • Plastic wrap that is specially marked for micro- wave use can be used for cooking and reheat- ing. DO NOT allow plastic wrap to touch food. Vent so steam can escape. • Lids that are microwave-safe

ABOUT MICROWAVE COOKING

• Arrange food carefully. Place thickest areas towards outside of dish. • Watch cooking time. Cook for the shortest amount of time indicated and add more as needed. Food severely overcooked can smoke or ignite. • Cover foods while cooking. Check recipe or cook- book for suggestions: paper towels, wax paper, microwave plastic wrap or a lid. Covers prevent spattering and help foods to cook evenly. • Shield with small flat p

PA R T N A M E S

1 Oven door with see-through window Be careful with the edge of the oven door as it is glass and could chip or break. 2 Door hinges 3 Waveguide cover: DO NOT REMOVE. 4 Turntable motor shaft 5 Oven light It will light when oven is operating or door is open. 6 Safety door latches The oven will not operate unless the door is securely closed. 7 Time display: Digital display, 99 minutes, 99 seconds 8 LIGHT HI/LO pad Press the LIGHT HI/LO pa

P A R T N A M E S

Number next to the control panel illustration indicates pages on which there are feature descriptions and usage information. 28 31 30 23 20 31 29 29 Words in the lower portion of the display will light to indicate what function is in progress. 24 27 31 20 31 21 R - 1 5 1 0 / R - 1 5 1 1 / R - 1 5 1 2 / R - 1 5 1 4

B E F O R E O P E R AT I N G

This is a 12 hour clock. If you attempt to enter an incorrect clock time, will appear in the display. Touch the STOP/CLEAR pad and re-enter the time. ERROR • Before operating your new microwave oven make sure you read and understand this operation manual completely. • Before the oven can be used, follow these procedures: 1. Plug in the oven. Close the door. The oven display will show . 2. Touch the STOP/C

Sharp Microwave Oven Owners Instructions: