GE EER3000 Installation Instructions Manual

Installation I Free-Standing Instructions Electric Ranges [] Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com I I EER3000, EER3001, JBP24, JBP26, JBP35, JBP48, JBP64, JBP66, JBP67, JBP68, JBP69, JBP71, I JBP78, JBP80, JBP82, JBP84, JB600, JB710, JB905, JB968, JB988 BEFORE YOU BEGIN Read these instructions completely a ...

FOR YOUR SAFETY: All rough-in and spacing dimensions must be met for safe use of your range. Electricity to the range can be disconnected at the outlet without moving the range if the outlet is in the preferred location (remove lower drawer). To reduce the risk of burns or fire when reaching over hot sur ...

See illustrations for all rough-in and spacing dimensions. The range may be placed with 0" clearance (flush) at the back wall and side walls of the cabinet. Acceptable electrical outlet area. Orient the electrical receptacle so the length is parallel to the floor. f *'15" Min. *0"-_ IlL **30" Min. _ ***6" Mn. ...

cord with this appliance. Remove house fuse or open circuit breaker before beginning installation. This appliance must be supplied with the proper voltage and frequency, and connected to an individual properly grounded branch circuit ...

STRAIN RELIEF INSTALLATION [] Remove the wire cover (on the back of the range) by removing five (5) screws using a 1/4" nut driver. Do not discard these screws. 5 screws to remove wire cover Back of range Wire cover [] Remove the knockout ring (1%") located on bracket directly below the terminal block. To remove th ...

INSTALLATION _i WARNING: The neutral or ground wire of the power cord must be connected to the neutral terminal located in the center of the terminal block. The power leads must be connected to the lower left and the lower right terminals of the terminal block. [] Remove the 3 lowe ...

terminal screws from the terminal block. Insert the center bare wire (white/neutral) tip through the bottom center terminal block opening. On certain models, the wire will need to be inserted through the ground strap opening and then into the bottom center block opening. Insert th ...

I-_REPLACE THE WIRE COVER Replace the wire cover on the range back by sliding its left edge under the retaining tabs and replacing the five screws removed earlier. Make sure that no wires are pinched between the cover and the range back. t_°re cover t"e co;er [] REMOVE STORAGE DRAWER [] Pull the drawer out until i ...

[] Install the oven shelves in the oven and position the range where it will be installed. [] Check for levelness by placing a spirit level or a cup, partially filled with Spirit level water, on one of the oven shelves. If using a spirit level, take two readings--with the level placed diagonally first in one direc ...