Sharp R-408HS Supplemental Service Manual

Text of Sharp R-408HS Supplemental Service Manual

In the interest of user-safety the oven should be restored to its original condition and only parts identical to those specified

should be used. WARNING TO SERVICE PERSONNEL: Microwave ovens contain circuitry capable of producing very high voltage and current, contact with following parts may result in a severe, possibly fatal, electrical shock. (High Voltage Capacitor, High Voltage Power Transformer, Magnetron, High Voltage Rectifier Assembly, Hi

PRECAUTIONS TO BE OBSERVED BEFORE AND

DURING SERVICING TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY (a) Do not operate or allow the oven to be operated with the door open. (b) Make the following safety checks on all ovens to be serviced before activating the magnetron or other microwave source, and make repairs as necessary: (1) interlock operation, (2) proper door closing, (3) seal and sealing surfaces (arcing, wear, and other damage),

WARNING TO SERVICE PERSONNEL

Microwave ovens contain circuitry capable of pro- ducing very high voltage and current, contact with following parts may result in a severe, possibly fatal, electrical shock. (Example) High Voltage Capacitor, High Voltage Power Trans- former, Magnetron, High Voltage Rectifier Assem- bly, High Voltage Harness etc.. Read the Service Manual carefully and follow all instructions. Before Servicing 1. Disconnect the power

MICROWAVE MEASUREMENT PROCEDURE

A. Requirements: 1) Microwave leakage limit (Power density limit): The power density of microwave radiation emitted by a microwave oven should not exceed 1mW/cm2 at any point 5cm or more from the external surface of the oven, measured prior to acquisition by a purchaser, and thereafter (through the useful life of the oven), 5 mW/cm2 at any point 5cm or more from the external surface of the oven. 2) Safety interlock

Sharp R-408HS SHARP ELECTRONICS CORPORATION

SHARP PLAZA, MAHWAH, NEW JERSEY 07430-2135 SUPPLEMENTAL SERVICE MANUAL MICROWAVE OVEN R-408HS FOREWORD This supplemental Manual has been prepared to provide Sharp Electronics Corp. Service Personnel with Operation and Service Information for the SHARP MICROWAVE OVEN, R-408HS. Model R-408HS is quite similar to base models R-410HK/HW & R-409HK (Ref.# S33M206R410HE) It is recommended that service personnel carefully stu

This oven is equipped with a three prong grounding plug. It must be plugged into a wall receptacle that is properly installed

and grounded in accordance with the National Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. WARNING: Improper use of the grounding plug

a qualified electrician and have it replaced with a properly grounded

three-pronged wall receptacle or have a grounding adapter properly grounded and polarized. If the extension cord must be used, it should be a 3-wire, 15 amp. or higher rated cord. Do not drape over a countertop or table where it can be pulled on by children or tripped over accidentally. CAUTION: DO NOT UNDER ANY CIRCUMSTANCES CUT OR RE- MOVE THE ROUND GROUNDING PRONG FROM THIS

Sharp R-408HS Key unit ribbon cable

Key unit (Membrane Switch) front view G10 G11 G12 G13 G9 G8 G7 G6 G5 G4 G3 G2 G1 POPCORN 9 3 6 2 5 8 0 1 4 7 TIMER CLOCK COOK START STOP CLEAR POWER LEVEL CLEAR DEFROST MINUTE PLUS REHEAT * * * * When door is close, key can be operated. TEST PROCEDURES PROCEDURE LETTER COMPONENT TEST J KEY UNIT TEST 1. Disconnect the power supply cord, and then remove outer case. 2. Open the door and block it

Sharp R-408HS Figure S-3. CPU Unit Circuit (R-408HS)

R74 - R78:270Kx5 C60 - C64:330pF/50Vx5 OVEN LAMP TURNTABLE MOTOR FAN MOTOR POWER TRANSFORMER DOOR SENSING SWITCH G10 G11 G12 G13 G9 G8 G7 G6 G5 G4 G3 G2 G1 NO NO B-1 B-2 C1 R3 C2 R2 2SA933AS R5 Q2 R6 3.3K 1/4W 10u/35V C5 D5 D6 27 1/4 W R4 510 1/2W (J1) VRS110G471K -5V INT BZ M D1 - D4 2200uF 25V AN5 AN6 P20 P21 P22 P23 P24 P25 P26 P27 AN7 IC1 BL NL CF1

Note: The parts marked “∆∆∆∆∆” may cause undue microwave exposure.

The parts marked “*” are used in voltage more than 250V. "§" MARK: PARTS DELIVERY SECTION. ∆ ELECTRIC PARTS 1- 1 RC-QZB018MRE0 M High voltage capacitor 1 AQ 1- 2 FH-DZB013MRY0 M High voltage rectifier assembly 1 AK 1- 3 QSOCLB006MRE0 M Oven lamp socket 1 AE 1- 4 RLMPTA086WRZZ M Oven lamp 1 AD 1- 5 RMOT

HOW TO ORDER REPLACEMENT PARTS

To have your order filled promptly and correctly, please furnish the following information. 1. MODEL NUMBER 2. REF. NO. 3. PART NO. 4. DESCRIPTION Order Parts from the authorized SHARP parts Distributor for your area. Defective parts requiring return should be returned as indicated in the Service Policy. REF. NO. PART NO. § DESCRIPTION Q'TY CODE MISCELLANEOUS 6- 1 FW-VZB125MRE0 M Stop switch harness 1 AF 6- 2 FW-V

OVEN AND CABINET PARTS

2-3 4-7 6-6 1-5 4-6 4-8 4-9 6-4 6-3 2-1 7-5 1-10 4-10 7-2 7-2 4-3 1-11 1-8 7-3 7-5 7-5 7-6 4-2 7-4 1-9 1-3 1-4 7-1 1-7 1-7 4-4 7-1 4-1 1-1 1-2 2-2 2-2 2-2 2-2 7-4 7-4 4-11 7-4 6-5 1-6 4-5 1-12 7-4 7-7 7-4 7-7 1-6

Actual wire harness may be different from illustration.

6-8 6-2 6-1 3-3 3-2 3-5 3-1 3-4 3-6 5-1-2 5-1-1 5-6 5-4 5-3 5-2 5-7 5-8 Items 5-7, 5-8 & 5-9 are not included with assembly 5-1 or 5-6 5-5 5-9 Control Panel Parts Door Parts Miscellaneous 5-1

PACKING AND ACCESSORIES

DOOR PROTECTION SHEET PLASTIC BAG PACKING CASE TOP PAD ASSEMBLY INTO THE OVEN CAVITY 6-4 TURNTABLE TRAY 6-7 OPERATION MANUAL BOTTOM PAD ASSEMBLY TRAY HOLDER 6-3 TURNTABLE SUPPORT ON TOP OF THE OVEN Non-replaceable items

2003SHARP CORP. (3M2.00E) Printed in U.S.A

COPYRIGHT © 2003 BY SHARP CORPORATION ALL RIGHTS RESERVED. No part of this publication may be repro- duced, stored in retrieval systems, or trans- mitted in any form or by any means, elec- tronic, mechanical, photocopying, recording, or otherwise, without prior written permission of the publisher.

Sharp Microwave Oven Owners Instructions: