Sharp R-8000E Service Manual

Text of Sharp R-8000E Service Manual

CONVECTION MICROWAVE OVW-

R-%OOOE In the interests of user-safety the set should be restored to its original qdition and only parts identical to those specified used. RATION - ’ ’

This service manual is prepared to provide Sharp service

personnel with complete service information on Sharp Convection Microwave Oven. Basic, general information for Sharp Microwave Ovens is given in the GENERAL service manual. Therefore, to permit them to give satisfactory customer service, it is recommended that service personnel first study the entire text of GENERAL manual, and then carefully study this book. CAU

CNUTION, MICROWAVE RADIATION ....................................................

1 THUMB INDEX ..................................................................... 1 CHAPTER I PRODUCT DESCROPTION ................................................... 4 Specifications ................................................................... 4 Features of Contr

CHAPTER IV COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURES. . . . . . . . . . . . . . . . . . . . .

Warning.......................................................................2 4 Outer Case Removal. ............................................................. .24 OvenLampRemoval....................................................~.........2 4 Power Transformer Removal ........................................................ .24 RectifierRemoval........

Microwave output power

Convection output power Case dimensions Width Height BPfi Cooking cavity dimensions Width Height &Ph Turntable diameter Control complement Weight Single phase, 3 wire earthed 1.3kW (Microwave), 1.4kW (Convection) 650W (2 litre water load) 1.3kW nominal of Sheath Heater 552mm 395mm including feet 500mm 340mm 255mm 36Ornr-n 325mm Cook Switc

Indicator Lamp for Convection Cooking (Orange)

------Timer for Convection Cooking Temperature (Heater) Indicator Lamp (Red) Temperature Control for Convection Cooking Indicator Lamp for Microwave Cooking (Green) Variable Cooking Control 7&r : FULL POWER (HIGH) A- : ROAST (MEDIUM HIGH) fr : SIMMER (MEDIUM) A- *.. : DEFROST (MEDIUM LOW) t. liT : WARM (LOW) I Timer for Microwave Cooking Cooking Start Button

1. Place the food to be cooked in the oven and close the

door firmly. 2. Set the variable cooking control for a desired position. 3. Set the microwave timer for a desired cooking time. The oven lamps will come on and the fan motor will rotate immediately. Note: When setting the timer for less than 1 minute, turn the past 2 minutes position and back to the correct time. Note: Make sure that the

Sharp R-8000E Closing the door activates both door latch switches; upper

latch switch and lower latch switch. Microwave : Selecting a cooking time closes the microwave timer contacts (7) -(8) leading to the oven lamps and fan motor, therefore the oven lamps and fan motor turn on, Figure 2. Convection: Selecting a cooking time closes the convection timer contacts 0-a leading to the oven lamps and fan motor, therefore the oven lamps and @n motor turn on, Fi

Sharp R-8000E Set the preheating temperature by turning the temperature

control knob (at 90°C to 25O”C), and preheating time at 20 minutes. When the “Cooking Start” button is pushed the following operations occur: (Figure 5). 1. The contacts @ - @ of convection timer and cook switch are closed. The fan motor, oven lamps and turntable motor are energized. 2. The contacts @ -@ of convection timer is closed. The convection timer and convection l

1. DOOR CLOSED

CONVECTION 0 TURNTABLE 1 IA-.-A- L---- -___ ---1 ----r-- ------- ---- -- MICRO A nnwv2nlAiauc TllhRCD & TIMER I.II”b .“..A” L I IIWL” 4c ,, CONTACTS MICROWAVE (3) LAMP 0 I’ TIMER 1 CONTACTS 0 THERMOSTAT THERM0 ( 1 SWITCH ((2) -01 JT VARI-MOTOR -- --I ’ I 0 1 SURGE LIMITING RESISTOR SURGE LIMITING RELAY

220V 50Hz LINE BYPASS CAPACITOR a J-7 r LOWER LATCH SWITCH ‘% ‘r, -\ cc, ___.. -. ‘. ; r---- ---- 1 I@--; 1 I E e I I- ____ -----J m FUSE 250V T6.3A RESISTOR FAN MOTOR - RESISTOR Ty-T LINE ACROSS CAPACITOR & n+ MAGNETRON THERM0 CUT. h LINE BYPASS 7 CAPACITOR -OUT ZOM -1 INC OVEN LAMP TURNTABLE UPPER LATCH SWITCH I COOK CONVECTION 0 -- -1 0’ SWITCH THERMOSTAT MICROWAVE LAMP VARI-MOTOR ----- 0 LJ SURGE _ _ ---- ------- LIMITING RESISTOR SURGE LlMlTlh

CAPACI TOR ,

FAN MOTOR LINE ACROSS CAPACITOR LINE BYPASS CAPACITOR LOWER LATCH SWITCH SCHEMATIC NOTE: CONDITION OF OVEN 1. DOOR CLOSED 2. CONVEC. TIMER “ON” 3. TEMP. CONTROL “#400C” i OVEN LAMP r-l _ COM -- I TURNTABLE MOTOR MAGNETRON THERM0 CUT-O\ UPPER CONVECTION , LAMP I--- L I- u-l ________ ,-I ____ ---- ----- ii MICRO MICROWAVE TIMER TIMER ,, CONTACTS MICROWAVE (4) (
1. DOOR CLOSED 2. MICRO. TIMER “ON” 3. VARIABLE COOKING” CONTROL ““FULL POWER” 4 . COOK SWITCH”ON” SURGE LIMITING RELAY -. I -_ ~-- -- - RECTIFIER CAPACITOR - MAGNETRON I FUSE 250V T6.3A LINE BYPASS A CAPACITOR / MA
1. DOOR CLOSED 2. CONVEC. TIMER “ON” 3. TEMP. CONTROL “90°C to 25O’C” 4. COOK SWITCH “ON” r---- ---- 1 I FUSE 250V T6.3A - 1 RESISTOR TyT LINE . : RESISTOR LINE ACROSS CAPACITOR BYPASS A CAPACITOR 7 FAN MOTOR - hEE[ 5%OUT r I T 1 AT-t-” - TURNTABLE LPiIb” SWITCH COOK I ; LAMP r--------- -1 I ; SHEATH THERMOSTAT 0 ; HEATER 4) ( THERM0 SWITCH ) ; CONVECTION \J Y 1 MOTOR

Sharp R-8000E VARIABLE COOKING CONTROL

The variable cooking control consists of the vari-motor, the power transformer intermittently within a 30 vari-switch, gear, select lever bracket assembly, etc. seconds time base. A half (l/2) of full power would be the purpose of the vari-motor is to rotate a cam which approx. 16 seconds of the switch on the 14 seconds of off is going to turn the vari-switch on and off within 30 time. The fol

Timer switch contacts:

Timer motor: The timer switch contacts are mechanically opened or closed by turning the timer knob located on the timer motor shaft. The contacts (7)-(8) control the current path to the oven lamps and fan motor, etc. The contacts (2)-(3) control the current path to the microwave timer, microwave lamp, vari-motor and power transformer through the vari-switch.etc. Timer is single speed type: cook time from 0 to 120 minu

DOOR OPEN MECHANISM

The door can be opened by pushing the open button on the control panel, refer to Figure 7. Pushing the open button, the open plate on the open device pushes the door lever on the door. Therefore, the lower and upper latch heads remove upwards, and then those latch heads are released from the lower and upper latch hooks. Now, the door can be opened. UPPER AND LOWER LATCH SWITCHES The upper latch switch is mounted in the upper latch hook

The thermostat is composed of thermo-rod, shaft, contacts

etc. The oven cavity temperature is sensed through a pushed hole provided at the cavity rear by means of the thermo-rod. Furthermore, the oven cavity temperature can be preset by turning the temperature control knob to a desired position. Setting temperature range : 4O”C, 90°C to 250°C Thermostat contacts connected to sheath heater, convection motor and heater lamp. 1. During cook cyc

CONVECTION COOKING SYSTEM

This oven is designed with a hot air heating system where food is not directly heated up by the sheath heater, but is instead heated by forced circulation of the hot air produced by the sheath heater. The air heated by the sheath heater is circulated through the convection passage provided on the outer casing of the oven cavity by means of the convection fan which is driven by the convection motor. It then enters the inside of ove

troubleshooting the microwave oven, it is helpful to

follow the Sequence of Operation in performing the checks. Many of the possible causes of trouble will require that a specific test be performed. These tests are given a procedure number which will be found in the “Test Procedure and Adjustment” section on GENERAL or this service manual. IMPORTANT: United Kingdom and Australia Models. If the oven become

Sharp Microwave Oven Owners Instructions: