Ricoh FW830 Operating Instructions Manual

symbols for the main switch: Note to users in the United States of America Warning: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harm ...

This manual contains detailed instructions on the operation and maintenance of this copier. Please keep this manual in a handy place near the machine. If you want to make a copy using the manual feed tray turn to page 3. If you want to use the sheet feeder, turn to page 14. If you want to use the roll feeder, turn to page 16. If you w ...

About seven minutes are required from power on until the copier warms up and copying is possible. Switch the copier on in the morning and off when the work day is finished. 1–1. Switching on the copier 1. Turn on the main switch. 2. The Wait indicator lights. 3. After about seven minutes, the Ready indicator lights, and copyi ...

1. If copying is under way, wait until it finishes or press the Clear/Stop key to cancel copying. • Turning off the copier during copying may cause a paper misfeed or machine failure. 2. Turn off the main switch. • Leave the copier plugged in if you use it often. Unplugging the copier disables the anti-condensation heaters ...

Manual feed refers to making copies by placing copy paper on the manual feed table. The method explained here does not use the sheet or roll feeders (optional equipment). Avoid using inappropriate paper (see page 51). 1. Check that the Ready indicator is lit. 2. Press the Paper Select key to light the Manual Feed indicator. 3. Pre ...

cator is lit. 5. Adjust the original guide to match the size and direction of the original. 6. Insert the original face up and straight along the original guide. The copier automatically feeds the original in. 7. Check that the Insert Copy Paper indicator is lit. 4 ...

desired paper size and direction (lengthwise or sideways). 9. Insert the copy paper. When the original and the copy paper are set, copying starts automatically. To cancel copying, press the Clear/Stop key once. (You may also cancel copying by pressing the Stop key on the indica- tor panel. However, doing so will crea ...

The Auto Image Density function automatically adjusts the density of the copy to keep dark backgrounds from appearing. This function is active when you turn on the machine, or when you press the Stand-by/Clear Modes key or Auto Image Density key. It can handle most copy jobs, but if copy density is too dark or too light, adjust the ...

You can change the copy exit direction to match the paper size. Use the lower copy exit for larger copy paper. This will prevent paper from hindering copying or from becoming crumpled. Press the Copy Exit key on the opera- tion panel. • Select the paper exit to match the pa- per size. Select the upper paper exit for paper up to D size ...