Dyson DCO1 Operating Manual

Text of Dyson DCO1 Operating Manual

Do not leave your Dyson cleaner with the plug

connected to a mains outlet – unplug when not in use. Turn the cleaner off with the switch button before removing from the mains outlet. 2. Always remove the plug from a mains outlet before carrying out any maintenance. Do not carry out any maintenance work on the cleaner other than that outlined in this manual, especially where electrical components are concerned. 3. Do not use without the clear bin assem

Wand & hose assembly

Push yellow hose cuff firmly over wand end with twisting motion. 1.Getting started Cleaner head adjustment Hold the cleaner head down with foot and tilt machine back. On/Off switch Cord storage Wrap cord around both cable winders. Accessory tool location All tools are stored neatly on the tool storage posts. Cleaner head adjusts automatically to correct height. Guide wand into hose, keeping it straight. Locate wand handle into socket f

Clear bin capacity

Do not fill above this line. Clear bin removal & emptying 1 2 3 2.How to use DANGER! Press yellow bin catch to release bin. Carrying handle Ensure clear bin is firmly in place before lifting. Remove clear bin and cyclone top from machine by lifting up until it releases. Remove clear bin from cyclone top and wrap a plastic bag around the rim of the clear bin. 4 5 6 Invert clear bin and wait at least 10 seconds before releasing. Wipe shrou

1. Remove soleplate

Undo three cross-head screws. Remove soleplate by lifting from the back, and then remove brush bar. If cradle becomes detached from soleplate, align circular ends of cradle with corresponding holes of soleplate and slot into place, ensuring that ‘front’ edge of cradle faces the right direction. 3. Centralise belt 2. Line up brush bar Thread removal After unplugging the cleaner, carefully remove any entwined cotton, wool or fluff wit

4. Blockage procedure

1. Check filters Filter life is dependent on the amount the vacuum cleaner is used. The S-level filter must be replaced at least every 3 months. The HEPA filter must be replaced at least every 12 months. 3. Check wand/hose 2. Clean shroud 4. Check belt & soleplate 5. Check cleaner head & flaps 6. Check yellow bin inner Wipe shroud holes free of all dust/debris. Check air duct behind bin for debris. Check that yellow bin inner is in pl

Check both filters

whenever the bin is emptied and replace as necessary. Please note that if the filters are not checked regularly and changed as required, the motor may overheat, which will cause the thermal cut-out to operate. NOTE: Vacuuming builder’s dust and some carpet fresheners may cause the filters to require changing more frequently. (Dyson does not recommend the use of carpet fresheners). Replacement filters are available from your local retai

Dyson Vacuum Cleaner Owners Instructions: