Smeg DW410ST3A Instruction Manual

Text of the manual

G TTHHEE DDIISSHHW

WAASSHHEERR AANNDD TTHHEE W WAASSHHIINNG G PPRRO OG GRRAAM MSS

Description of the controls________________________________14

2. Troubleshooting _______________________________________20 Thank you for choosing one of our products. You are advised to read this manual carefully; it contains all the information you need about the right conditions for the proper, safe use of your dishwasher. The individual sec

1. Description of the controls

1.1 Upper panel All the dishwasher controls are grouped on the upper panel. 1 ON/OFF BUTTON Pressing this button energises the appliance. 2 SELECTED PROGRAM INDICATOR LIGHTS Illumination of this light denotes the program selected and the occurrence of a fault (troubleshooting). 3 PROGRAM SELECTION BUTTON By

After using the table to identify the most appropriate washing program:

• press the ON/OFF button (1) and wait for the PROGRAM INDICATOR LIGHT (2) to illuminate; • keep pressing the PROGRAM SELECTION button (3) until the indicator light corresponding to the desired program illuminates; • close the door; after about 2" the program w

TABLE FOR CERTIFICATION BODIES

Reference standard EN 50242 Reference program ECO Load 10 place-settings Type of detergent B Amount of detergent 25 g Rinse aid setting 5/6 1.2 Washing programs Before starting a washing program make sure that: • The water supply tap is open. • The correct amount of detergent has been added to the dispe

CHANGING THE PROGRAM

To change the program in progress, simply open the door and select a new program. When the door is closed the dishwasher will automatically select the new program. DELAYED START (certain models only) The start of the program can be delayed by 3, 6 or 9 hours. This allows you to set the dishwasher to work at the times

WATER HARDNESS TABLE

WATER HARDNESS German Degrees (°dH) French Degrees (°dF) SETTING 0 - 4 0 - 7 Setting N. 1 NO SALT 5 - 15 8 - 25 Setting N. 1 16 - 23 26 - 40 Setting N. 2 24 - 31 41 - 60 Setting N. 3 32 - 47 61 - 80 Setting N. 4 48 - 58 81 - 100 Setting N. 5 Contact your local water board for information on the hardness of your wat

TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT

• Always try to run the dishwasher fully loaded. • Do not wash the dishes in running water. • Use the washing program that is most appropriate for each type of load. • Do not carry out any preliminary rinsing. • If available, connect the dishwasher to a hot water supply up to 6

The dishwasher is capable of signalling a number of faults through the

simultaneous illumination of several indicator lights, with the following meanings: FAULT DESCRIPTION E1 Acquastop failure The anti-flooding system has been activated (for the relevant models only). The system is tripped in case of water leaks. Cont

If an alarm occurs the appliance interrupts the program in progress and

signals a fault. • Alarms E1, E3, E4 interrupt the current program immediately. • The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach the execution of the program. To “reset” an alarm is necessary: • Open and clos

Other Other Manuals