Gigabyte Adaptec 7902W chip Configuration

Text of Gigabyte Adaptec 7902W chip Configuration

Server Systems and

Motherboards Raid Configuration and Driver installation guide For Adaptec 7902W chip

1. RAID Configuration

1.1 RAID Definition ………………………………………….. 3 1.2 Installing disk drives ……………………………………. 3 1.3 Setting the RAID in BIOS ……………………………….4 1.4 Adaptec 7902W RAID configuration utility ……….4 1.4.1 Create a RAID 0 (Striped) ………………………………7 1.4.2 Create a RAID 1 (Mirrored) …………………………….9 1.4.3 Create a R

1. RAID Configuration

GIGABYTE server systems and motherboards that a RAID supports is comply with the following RAID solutions: ● Hardware RAID: Use dedicate hardware to control RAID array, and supposed to doing RAID 0, 1, 1+0, 5 configurations through software utility. ● Software RAID (Host RAID): Use BIOS setup and management utility complete RAID 0, 1, 1+0, Spare configurations and support Ultra 320 products. ● SATA RAID: Adaptec SATA RAID is

1.3 Setting the RAID in BIOS

Since onboard RAID controller option, please enable onboard H/W SCSI capability of the BIOS utility before you creating. 1) During the POST screen, please enter the BIOS setup utility. 2) Into Advance Menu > click Integrated Peripherals screen item. 3) Choose Onboard Device item > Onboard H/W SCSI [Enable]. 4) Save your change and Exist BIOS setup. 1.4 Adaptec 7902W RAID configuration utility Adaptec 7902W RAID controller is

After into SCSI Disk Utility screen, you can check your SCSI hard disk

drives be detected on your system, in general, a SCSI bus can support up to 15 devices and the controller connected to its 16-bit bus. Return Options, choose “Configure/View SCSI Controller Settings”. Select HostRAID options and “Enabled” it.

Save Changes Made screen will pop-up , please click “Yes”.

Options item will become 3 selections, please pull down to “Configure/View HostRAID Settings”.

Click “Configure/ View HostRAID settings” icon that will allow you to

check and create RAID array or Spare capability of SCSI hard disk drives. 1.4.1 Create a RAID 0 (Stripe) From the Create RAID menu, please click “RAID-0 (High Performance, No Fault Tolerance)” that disk drives set requires for the maximum of 4 drives. All required SCSI hard disk drives will appears in the Select RAID members screen.

Select default Strip size 64-KB from the menu, then press .

(Of course, you also can select 16-KB or 32-KB by your application) Enter 1 ~15 alphabetic or numeric characters to assign RIAD name and press to proceed. If you would like to set this array on bootable, please select “Yes” on this window and apposite, please select “No”.

The RAID-0 is complete the array propertied.

After configure successfully, please exit Adaptec SCSISelct Utility window and restart system. 1.4.2 Create RAID 1 ( Mirrored ) From the Create RAID menu, click RAID-1 (Fault Tolerance) that disk drives set requires for the maximum of 2 drives.

Gigabyte Computer Hardware Owners Instructions: