Panasonic WJND300 - NETWORK DISC RECORDR Setup Instructions

please read these instructions carefully and save this manual for future use. Network Disk Recorder Setup Instructions Model No. WJ-ND300 ALARM ALARM SUSPENDED ERROR TIMER REC OPERATE 1-LINK/ACT-2 HDD 1 HDD 2 HDD 3 ESC PULL Network Disc Recorder WJ-ND300 300 SET HDD 4 PRELIMINARY ...

...

recordings and playbacks pictures from network cameras in the system. The network disk recorder is a recording device using a hard disk drive to record camera pictures instead of using videotapes so that pictures recorded by repeated o ...

There are 3 sets of operating instructions for the WJ-ND300 as follows. • Installation Guide (book) • Operating Instructions (PDF) • Setup Instructions (PDF, these operating instructions) These "Setup Instructions" contain descriptions of how to perform the required settings to operate this unit using a PC via a net ...

Microsoft® Windows® 2000 Professional Service Pack 4 is described as Windows 2000. Microsoft® Windows® XP Professional SP1a or SP2 and Microsoft® Windows® XP Home Edition SP1a or SP2 are described as Windows XP. Terms Used in these Operating Instructions HDD Refers to ...

(Alarm Mode), ADM (Activity Detection Mode), and are selectable. In ALM, the occurrence of an event is announced by screen display, LED, or buzzer (Alarm Operation). In ADM, the occurrence of an event is not announced, but the unit ...

Rack Mounting Install the unit in the rack. Refer to the Installation Guide for further information about rack mounting. ➜ z Connections Connect PCs, cameras and extension units. Start connections in the following order: PC → Cameras →Extension units Refer to the provided Installation Gui ...

Screenshot 1 Start operation when the standby display is displayed on the LCD. Step 1 Display the IP address setup display by pressing the arrows button (C or D). With the following network environment, it is not necessary to perform the network settings. It is possible to perform the settings or operate this unit using a we ...

Screenshot 4 The setup item display for each item will be displayed. Step 5 After confirming that the cursor is positioned on "l", press the [Set] button, and move the cursor to the num- ber area. Step 6 Set the value as follows. The cursor appears as a "_" (underscore). To move the cursor: Press the a ...