Wegener DTV742 Installation & Quick Start Manual

Text of the manual

800057-02 Rev. A

Page 1 of 11 May 24, 2003 DTV742 Installation Quick Start Guide The Wegener Model DTV742 8VSB 4-Channel Multiplexor receives VHF/UHF broadcast HDTV signals and provides output ASI streams for connection to cable system QAM modulators. This guide provides information for setting up and operating the DTV742. Additional information may be found

800057-02 Rev. A

Page 2 of 11 May 24, 2003 Basic System Setup Diagram Front-panel User Interface Note that from any screen, pressing the ESC key twice will return you to the Home Screen. Main-level Screens Second-level Screens Home Screen (rotates through data from each of the four RF inputs) The channel number, modulation type (8VSB, 64QAM, or 256QAM), sig

800057-02 Rev. A

Page 3 of 11 May 24, 2003 Main-level Screens Second-level Screens 2nd-level RF Input Where X is the RF port number. Press ENT to go to the third-level Input Setup Screens below and use the 5 or 6keys to select or , adding or removing this program to/from the output stream. Press ENT again to confirm. Press the 4 key to go to the ne

800057-02 Rev. A

Page 4 of 11 May 24, 2003 Main-level Screens Second-level Screens 2nd -level Program Status where X is the input port number. Press the ENT key to go to the third-level program status screen. Press the 4 key to go to the next input (1 through 4). Press the ESC key to return to the main-level Program Status screen. Program Status Press the EN

800057-02 Rev. A

Page 5 of 11 May 24, 2003 Main-level Screens Second-level Screens IP Address Selection Press the ENT key and then press the arrow keys to change the IP address. Press the ENT key to confirm the selection or ESC to cancel changes. Press the 4 key to go to the Netmask Selection. Press the ESC key to go to IP Setup. Netmask Selection Press the

800057-02 Rev. A

Page 6 of 11 May 24, 2003 Using the Web Browser – Using the web browser of your choice, set the Address to http://nnn.nnn.nnn.nnn where nnn.nnn.nnn.nnn is the IP address of the unit to be controlled. Each unit on the network must have a unique address. You should see the pages below when connected to the unit. (Be sure that your screen re

800057-02 Rev. A

Page 7 of 11 May 24, 2003 The Stream Information tab below shows input and output status. No user inputs are located on this screen. The Unit Configuration tab below shows the current configuration in use and allows storage and loading of 10 separate configurations. A configuration is the set of all user settable items (inputs and outputs) i

800057-02 Rev. A

Page 8 of 11 May 24, 2003 The Config In tab below provides the interface for selecting the RF Input and Program numbers that will be used in all four of the DTV742’s multiplexors.

800057-02 Rev. A

Page 9 of 11 May 24, 2003 The Config Out tabs (Config Out 1 illustrated below) provide the interface for selecting programs for each of the ASI outputs. A separate tab is used for each output (1, 2, 3, and 4).

Other Home Theater Server Manuals