Snapper EJAV20441BVE2 Dealer Setup & Adjustment Instructions Manual

Zero-Turn Riders & Mowers TABLE OF CONTENTS: SAFETY RULES .................................................................2 SETUP PROCEDURES Quick Setup List ................................................................5 Uncrating........................................................ ...

TP 300-5241-00-HZ-SN 10/2006 2 IMPORTANT SAFETY INSTRUCTIONS WARNING: This powerful cutting machine is capable of amputating hands and feet and can throw objects that can cause injury and damage! Failure to comply with the following SAFETY instructions could result in serious injury or death to the operator or other persons. The owner ...

10/2006 3 TP 300-5241-00-HZ-SN IMPORTANT SAFETY INSTRUCTIONS PREPARATION (Continued From Previous Page) 6. Check the area to be mowed and remove all objects such as toys, wire, rocks, limbs and other objects that could cause injury if thrown by blade or interfere with mowing. 7. Keep people and pets out of mowing area. Immediately STO ...

TP 300-5241-00-HZ-SN 10/2006 4 IMPORTANT SAFETY INSTRUCTIONS TOWING 1. Tow only with a machine that has a hitch designed for tow- ing. DO NOT attach towed equipment except at the hitch point. 2. Follow the manufacturer's recommendation for weight limits for towed equipment and towing on slopes. 3. DO NOT allow children or others on tow ...

10/2006 5 TP 300-5241-00-HZ-SN Quick Setup List - Page Setup Procedure Steps to Perform 6 Uncrating ❏ Remove crate & banding. ❏ Place transmissions in ROLL RELEASE position & roll off skid. 7 Battery Activation & ❏ Charge the battery (Note: proceed with other setup steps Installation while battery is charging). ❏ Install & secu ...

TP 300-5241-00-HZ-SN 10/2006 6 Uncrating 1. Using a reciprocating utility saw or equivalent, cut crate away from bottom skid. Remove crate. Remove plastic wrap. 2. Cut any banding securing the unit. 3. Place transmissions in the roll release position by pushing the roll release rods (A, Figure 1), located under the rear of the unit beh ...

10/2006 7 TP 300-5241-00-HZ-SN Battery Activation & Installation Charge Battery 1. Tip the seat forward to access the battery. 2. Remove the battery from the battery compartment, and place the battery on a level, non-concrete sur- face. Note: When removing the battery cables from the bat- tery, always remove the negative (-) cable firs ...

TP 300-5241-00-HZ-SN 10/2006 8 Check Fluid Levels Fill & Check Engine Oil Removing the rear cover to gain access to the engine, use the dipstick (A, Figure 3) to check the engine oil level. If necessary add engine oil. Check engine manufacturer’s owner’s manual for oil recom- mendations. Figure 3. Check Engine Oil Level A. Engin ...

10/2006 9 TP 300-5241-00-HZ-SN Torque Mower Blades 1. Check that blades are installed with the tabs pointing up toward deck as shown in Figure 5. Secure with a nut, and two blade washers, concave side up. Use a wooden block to prevent blade rotation and torque nut to 80-90 ft-lbs. WARNING For your personal safety, blade mounting hard ...

TP 300-5241-00-HZ-SN 10/2006 10 Perform Safety Checks Functional Tests 1. Check for loose bolts, screws, nuts, etc. 2. Start the engine and check all controls for proper operation: motion control levers, engine speed and choke cables, electric PTO clutch, cutting height adjustment lever, etc. 3. Stop the engine and check for fluid leak ...