Ricoh MP7040S Manual
Text of the manual
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and use
Dieser Drucker überschreitet einen Geräuschpegel von 70 dB (A) während
dem Betrieb nicht.
Declaration of Conformity
“The Product complies with the requirements of the EMC Direc-
tive 89/366/EEC and the Low Voltage Directive 73/23/EEC.”
Please take notice that the manufacturer of this equipment does not
offer any warranty against data loss due to inappropriate installation
or handling, or direct or indirect damages.
Please take notice that the manufacturer will bear no responsibility
for direct or indirect damages caused by the use of this product or its
malfunction.
Please take
Obey the following cautions when handling the drive or discs.
Cautions During Installation
• Install the drive in accordance with the specifications. Be careful to
avoid locations likely to cause vibration or shock.
• Avoid locations where there is high humidity, much dust, or poor
ventilation.
• Avoid locations in direct sunli
Cautions Concerning Disc Cleaning
• Remove the disc by pressing the eject button.
• Use compressed air to clear dust from the drive. (Spray the com-
pressed air for about 5 seconds). (See Fig. 1)
• Check to see if there is dirt on the surface of the disc. Be careful not to
touch the disc with the fingers when doing this. (See Fig. 2)
• After cl
