Greenlee 854 Instruction Manual

safety information in this manual before operating or servicing this tool. 52033653 © 2007 Greenlee Textron Inc. 11/07 Serial Code AKM Español................ 23 Français............... 45 ...

Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070  All specifications are nominal and may change as design improvements occur. Greenlee Textron Inc. shall not be liable for damages resulting from misapplication or misuse of its products. Loctite is a registered trademark of Loctite Corporation. KEE ...

Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070  IMPORTANT SAFETY INFORMATION SAFETY ALERT SYMBOL This symbol is used to call your attention to hazards or unsafe practices which could result in an injury or property damage. The signal word, defined below, indicates the severity of the hazard. The ...

Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070  Extension cords: Use only three-wire, 12-gauge extension cords that have three- prong grounding-type plugs and three-hole receptacles that accept the tool’s plug. Do not use extension cords that are longer than 30 m (100'). Repair or replace dama ...

Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070  Grounding Instructions Electric shock hazard: Do not modify the plug provided with the tool. Connect this tool to a grounded receptacle on a 20 amp GFCI- protected circuit. Failure to observe these warnings could result in severe injury or death. � ...

Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070  Identification Specifications Height......................................................................................................1200 mm (47") Width........................................................................................... ...

Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070  Transportation and Setup Hoisting the Bender To hoist the bender, use either slings (nylon or polyester) or chains with hooks. Each side of the sling or chain must be at least 915 mm (36") long to prevent contact with the bender. All lifting compon ...

Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070  Operation Do not use this tool in a hazard- ous environment. Hazards include flammable liquids, gases, or other materials. Using this tool in a hazard- ous environment can result in a fire or explosion. Failure to observe this warning will result i ...

Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070  Operation (cont’d) 1. Mark the conduit. The decals on the bender and the Bending Instructions section of this manual provide basic instructions for marking and bending the conduit. They are based on measurements with common fractions for accura ...

Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070 10 Operation (cont’d) ADJUSTING THE SQUEEZE When bending 1-1/2" to 2" EMT, IMC, and rigid alumi- num conduit, the roller support must be engaged so that the roller supports the conduit; the pressure against the conduit is the “squeeze”. Settin ...