Panasonic AK-HRP200G Operating Instructions Manual

Operating Instructions Remote Operation Panel VQT4S52A (E) z z How the operating instructions are organized • Basics: This manual describes how to connect the unit to the required equipment and set it up. Before installing the unit, be sure to read the manual to ensure that you know how to install ...

Setup mode.......................................................................................... 4 Setup Mode Operations........... ...

handy camera (AK-HC3800) and a camera controller unit like the AK‑HCU200. Use a dedicated optical fiber cable to connect a studio handy camera to a camera controller unit and use a dedicated ROP cable (optional accessory) to connect this unit to the camera controller ...

Normal operation is unavailable during setup mode operation. ROP menu (REMOTE OPERATION MENU) operation is not available either.  „Setup mode functions Setup mode allows you to do any of the following. Item Adjustable range D ...

 „Opening setup mode Setup mode differs from normal operating modes. Use the steps below to open setup mode. 1. When a camera and CCU are connected, select IRIS (to light the display on the panel). If the IRIS display is not lit, press the selected button to select IRIS. CAMERA No. DATA SET DISPLAY SELEC ...

 „Setup mode menu configuration Setup mode is comprised of the menus and submenus listed in the table below. Menu Submenu Set value/Selected operation Default value CAMERA No. DATA SET DISPLAY SELECT UP DOWN SET UP ND/CC M.GAIN/M.PED SHUTTER ND M.GAIN IRIS M.PED 10-19 CC SHT SYNC SELECT EXECUTE EXIT SAVE/LOAD SHIFT + UP+DOWN CAM ...

Menu numbers 10 to 15 are for future use. 1. Set camera number 1. Open setup mode and check that menu number [1] is displayed. If a menu number other than [1] appears, press to select menu number [1]. CAMERA No. DATA SET DISPLAY SELECT UP DOWN SET UP ND/CC M.GAIN/M.PED SHUTTER ND M.GAIN IRIS M.PED 10-19 CC SHT SYNC SEL ...

Setup Mode Operations  (continued)

• To cancel loading, select [n] and press . • The file is loaded from the memory card and [Fin] appears when loading ends. • [E02] is displayed if the load operation from the memory card fails. (→page 13) If this happens, check the memory card and see whether the file exists on the memory card. If it do ...

Setup Mode Operations  (continued)

4 Save lens file to/load lens file from memory card Press

to select menu number [4]. CAMERA No. DATA SET DISPLAY SELECT UP DOWN SET UP ND/CC M.GAIN/M.PED SHUTTER ND M.GAIN IRIS M.PED 10-19 CC SHT SYNC SELECT EXECUTE EXIT SAVE/LOAD SHIFT + UP+DOWN Select file number, Select y (Select)/ n (Cancel) Save file indica ...

5-1 Save ROP configuration file to memory card 1. Press to select [ND]. • Each press of toggles between [ND] (Save) and [CC] (load). ND M.GAIN IRIS M.PED CC SHT SYNC 2. Press or to select [y] and press to confirm the selection. • Do not remove a memory card that is bein ...