Haier HBF205E Operation & User’s Manual

HBF205E Manual del Usuario Modelo HBF205E Dual Tap Beer Dispenser BrewMaster Conjuguent Fontaine à Bière BrewMaster Dobla Dispenser De Cerveza BrewMaster Quality n Innovation n Style ...

When using this appliance, always exercise basic safety precautions, including the following: 1. Use this appliance only for its intended purpose as described in this operation manual. 2.  This appliance must be properly installed in accordance with the installation instructio ...

1. CO2 gas can be dangerous! CO2 cylinders contain high-pressure compressed gas, which can be hazardous if not handled properly. Make sure you read and understand all the procedures for the CO2 cylinders before installation. 2.  Always connect the CO2 cylinder to a regulator! Failure to do so ...

SAFETY PRECAUTIONS.................................................................1-2 General Safety.................................................................................1 CO2 (Carbon Dioxide) Gas Safety......................................................2 UNPACKING AND ACCESSORIES INVENTORY......................... ...

tape holding the accessories both inside and outside. 2. Inspect and remove any remaining packaging, tape or printed materials before turning on the beer dispenser. Note: Allow the beer dispenser to stand in an upright position for 2 hours before turning on the power ...

2. Interior Keg Support 3. Cabinet 4. C02 Tank 5. Work Top 6. Chrome Guardrail 7. Dual Chrome Beer Tap 8. Adjustable Thermostat (Located in the rear) 9. Drip Tray 10. 1/4 Barrel Kegs (Not included shown for illustration purpose only) 11. Keg joining Bracket 7 8 6 5 9 4 3 2 1 10 11 English Parts and Features ...

designed for, install it in a location where there is proper air circulation, plumbing and electrical connections. • Choose a location where the beer dispenser will be away from heat and will not be exposed to direct sunlight. • This beer dispenser is designed for indoor use ...

beer dispenser. If after completing the process you are still unsure whether the beer dispenser has been properly installed, we recommend that you contact a qualified installer. Installing the Casters Follow the steps below to install the casters. 1. Empty the inside of the ...

Follow the steps below to install the guardrail on the worktop. 1. Place the guardrail on top of the cabinet. 2. Align all holes of the guardrail with the holes of the cabinet. 3. Secure the guardrail to the cabinet with eight small Phillips-Head screws. Installation Instructions Note: Your CO2 cylinder is shipped empty to avoi ...

Connect the CO2 regulator to tank by screwing regulator nut onto threaded tank valve. HAND TIGHTEN ONLY – it is not necessary to use a wrench to tighten this nut. At this point make sure that both the shut off (black) valves are in the off (side- ways) position. STEP 2 Attach one red gas hose to each of t ...