Haier HDW100SST User Instructions

Text of Haier HDW100SST User Instructions

Safety Is Very Important

Close-up View (Control Panel) A B "END" Light "POWER" Button Knob For Selecting Cycle Handle For Opening Door C D Carefully read the instructions contained in this manual, as it provides information that is essential to safe and proper installation, use and maintenance of this appliance. - Carefully remove and dispose of the packing material. - Check to make sure that the appliance is not damaged. If in doubt, contact the ret

Close-up View (Interior)

A B C D Upper Rack Rack Height Adjustor Top Spray Arm Lower Rack E F G Washing Filter Bottom Spray Arm Detergent and Rinse Aid Dispenser Technical Characteristics Width 60 cm Depth 60 cm Height 85 cm Capacity 12 standard place settings Mains water pressure 0.03-1 MPa Power voltage 220-240V~ 50Hz 2100W Total absorber power

Detergent and Rinse Aid⋯⋯

Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table." The detergent dispenser is located on the inside panel the door. Loading the detergent To open the "A" cover on the dispenser, press the "B" button. The detergent for the wash cycle should be poured into the "C" compart

Haier HDW100SST Loading the Dishwasher

Lower Rack Upper Rack Load for 12 Standard Settings Before placing the dishes in the dishwasher, remove the larger food particles to prevent the filter from becoming clogged. If the pots and pans have baked-on food that is extremely hard to remove, we recommend they are soaked before washing. This will eliminate the need for extra wash cycles. Pull out the rack to load the dishwasher. The lower rack Place the most difficult t

Turning on the Appliance

.5. Starting a wash cycle... Make sure that the plug for the appliance is inserted into the wall socket. Make sure that the water supply is turned on to full pressure. Load the dishes. Pour in the detergent. Press the "POWER" button, and the “END” light will turn on. Turn the knob located on the right of the control panel until the number or symbol for the cycle setting is aligned with the refrence mark (see the section entitl

- It is important to try and run the dishwasher when it is fully loaded

to save on energy. - Rather than run a full cycle for a half load, you can run the "PRE-RINSE" cycle which will prevent odours from forming and food from caking onto the dishes. - Choose the right wash cycle: the choice of cycle depends on the type of dishware, cookware and utensils being washed and how dirty they are. Energy Saving Tips - Use the right amount of detergent

Wash Cycle Table

.7. (*) AS/NZS 2007 test with rinse aid setting 5 Wash programme Description of cycle Pre-wash with hot water. Extended wash at 70°C. Rinses with cold water. Rinse with hot water. Drying. Prewash use cold water. Extended wash at 50°C. Rinse with cold water. Rinse with hot water. Drying. Hot rinse at 65°C. Drying. Short wash at 40°C. Cold rinse. Short cold wash to prevent food residue from drying on the dishes . Prewash use cold water.

Cleaning and Special Maintenance

Filter Assembly For the best performance and results, the filter assembly must be keep clean. The filter removes food particles from the wash water, allowing the water to be recirculated during the cycle. For this reason, it is a good idea to remove any food particles trapped in the filter after each wash cycle by rinsing the semi-circular filter and cup ("A") under running water. To remove the filter assembly, pull the ha

Haier HDW100SST Lid in detergent compartment cannot be closed

Detergent compartment has been overfilled. Mechanism is clogged with remnants of detergent. Remnants of detergent stuck inside dispenser Compartment was damp when it was filled up with detergent. Compartment must be dry before detergent is added. Water remains inside appliance after programme has ended Blockage or kind in drainage hose. Pump is jammed. Filters are blocked. The programme is still running. Wait f

Positioning the Appliance

Position the appliance in the desired location. The dishwasher is equipped with water supply and drain hoses that can be posi- tioned to the right or left to allow correct installation. Levelling the Appliance Once the appliance is positioned, adjust the feet by screwing them in or out. The appliance should not be inclined more than 2 degrees, to ensure proper performance. Cold Water Connection Connect the cold

Haier Dishwasher Owners Instructions: