Paradyne 12000E Installation Instructions Manual

Installation Instructions Document Number IPD1-A2-GZ40-10 July 2005 Contents Software and Firmware License Agreement ...................................................... 1 Introduction ........................................................................................................ 3 Unpac ...

under this purchase, such separate written agreement shall govern. Paradyne Corporation (“Paradyne”) grants to you, and you (“Licensee”) agree to accept a personal, non-transferable, non-exclusive, right (without the right to sublicense) to use the ...

Software and destroy the original and all copies of the Software in the possession of Licensee together with all documentation and related materials. 10. This Agreement shall be governed by the laws of the State of Florida, without regard to its provi ...

representative. Installation Options The 12000E BLC is designed for installation in a Restricted Access area where admittance is limited to trained and authorized service personel. It may be installed on a tabletop or in a rack. Installation on a ...

Procedure 1. Using a Phillips screwdriver, attach the two provided rack mount brackets to the sides of the 12000E with eight of the ten provided bracket screws. There are seven position options for the rack brackets; position them as best suited to the space available for your chassis on the rack being utilize ...

sides of the rack using one of the two provided sets of eight rack screws (whichever size fits the rack being utilized). 3. Check the rack for stability, ensuring that installation of the 12000E has not caused the rack to become top-heavy. Position and se ...

are reserved for interface modules and slots U1–U2 are reserved for management modules. Although the 12000E is shipped with Port U1 open, your management module can be installed in either Port U1 or Port U2. Only one management modul ...

management module model name upright, align the upper and lower edges of the PCB with the slot module guides. 3. Slide the management module firmly into the chassis. Tighten the fastening screws on the management module faceplate. MANAGEMENT MODULE Slot ...

Interface modules provide the subscriber connections for an 12000E; up to twelve interface modules may be installed in the 12000E (slots 1–12). There are a variety of models available for purchase; contact your sales representative for further information or visit www.paradyne.com for a list o ...

on the interface module faceplate. Fastening Screws ...