Peavey 1000 Operating Manual
Text of the manual
Intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
Intended to alert the user of the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the product.
CAUTIO
Congratulations on your purchase of the Peavey Nashvilleª 1000. As the leader in steel guitar
amplification, we are proud to combine innovation and tradition in this new model. Our digital amp
provides the clean power you require and reduces the weight, while the enhanced tone circuitry
eliminates the desire for unnecessary after-market mod
Step 10. To adjust the overall level, use the Master Gain control.
Step 11. To adjust out any undesirable distortion, use the Pre Gain knob. Turning the knob counter-
clockwise results in a decreased level, thus reducing the overdriven signal. Any external effects units
can also cause the signal to overdrive.
Step 12. You should be able to play at this ti
Post EQ Patch (8)
Similar to the Pre EQ Patch(4), these jacks are post EQ. The same notes apply. The return level
should still be monitored for its strength. In addition, the Post EQ Patch can be taken in and out of
the signal path via the footswitch.
Master Reverb (9)
Adjusting this control clockwise will result in more reverb content in the output of the a
NASHVILLEª 1000 SPECIFICATIONS:
6
Power Amplifier Section:
Rated Power and Load:
300 W RMS into 4 Ohms (with DDT compression)
190 W RMS into 8 Ohms (with DDT compression)
2 Ohms operation not recommend
Frequency Response:
+0,-3 dB, 20 Hz to 20 kHz @ 250 W RMS into 4 Ohms
Total Harmonic Distortion:
Less than 0.3%, 1 W to 300 W RMS, 20 Hz to 20 kHz, 4 Ohms
DD
Pre-EQ Effects Loop
EQ
Low Mid Shift High Pres.
Ft. Sw.
Switch
Logic
Send
Return
Post-EQ
Effects Loop
Ft. Sw.
Reverb
Level
Line
Out
Preamp
Out
Pwr
Amp In
Master
Gain
300W
Digital
Switching
Power Amp
4 Ohm
Speaker
Clean Single Coil Guitar
Steel: E9 Tuning
Steel: C6 Tuning
Lap Steel
Fiddle
Nashvilleª 1000
Recommended Tone Settings
*For CLEAN settings: the MASTER should be a higher setting than the PRE GAIN to avoid premature signal clipping.