Harman PELLET P61A Installation & Operating Manual

save these instructions. Installation & Operating Manual “Ce manuel est disponible en Français sur demande” SAFETY NOTICE Please read this entire manual before you install and use your new room heater. Failure to follow instructions may result in property damage, bodily injury, or even death. FOR USE IN THE U.S. AND ...

Ce modéle est dispensé par EPA certification d'aprés 40 CFR 60.531 par dèfinition [Appareil á bois (A) << Ratio air/combustible>>] US ENVIRONMENTAL PROTECTION AGENCY This model is exempt from EPA certification under 40 CFR 60.531 by definition [Wood Heater (A) "Air-to-Fuel Ratio"] Harman P61A Pell ...

Safety Information 5 Installation 6 Venting 8 ESP Control 15 Automatic Operation 16 Manual Operation 19 Low Draft Voltage Adjustment 21 Maintenance 22 Troubleshooting 27 Fuel Specifications 28 Mixing Corn with Pellets 29 Power Failure / Back-up 30 Options 31 Wiring Diagram 32 Specifications 32 Warranty 33 Service Parts 35 Division of Hear ...

DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST VENTING SYSTEM OF THIS UNIT. DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE. CAUTION THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL, AND CEILING/ ROOF MUST BE MAINTAINED. IMPORTANT NOTES Installation and repair of this Harman stove should be done by a qualified ser ...

Assembly and Installation Unpacking The P61A is bolted (1/4 x 1" hex head bolts) to the skid to prevent movement during shipping. To free the stove from the skid you must remove the hold-down bolts in the rear of the pedestal base. Removing rear cover panels The rear cover panels are secured to the stove with three bolts each. Two of the ...

Installing Place the stove on a noncombustible floor or on a floor protector that extends a minimum of 6 inches to the front, (measured from the glass) 6 inches to the sides and 1 inch to the rear of the hopper. It is also recommended that floor protection be installed under any horizontal venting and extending 2 inches beyond the vent me ...

Venting Requirements for Terminating the Venting WARNING: Venting terminals must not be recessed into a wall or siding. NOTE: Only approved pellet vent pipe, wall pass- throughs, and fire stops should be used when venting through combustible materials. NOTE: Always take into consideration the effects of the prevailing wind direction or ot ...

Vent Pipe Pellet venting pipe (known as PL vent) is constructed of two layers with air space between the layers. This air space acts as an insulator and reduces the outside surface temperature to allow a clearance to combustibles of 1 to 3 inches. The sections of pipe lock together to form an air tight seal in most cases. However, in some ...

Outside air flex pipe goes here. Inlet Cover part# 1-10-08542 Flex pipe part# 1-00-08543 (25') Per national building codes, consideration must be given to combustion air supply to all combustion appliances. Failure to supply adequate combustion air for all appliance demands, may lead to back-drafting of those and other appliances. When th ...

#2 Preferred method This method also provides excellent venting for normal operation but requires the stove to be installed farther from the wall. The vertical portion of the vent should be three to five feet high and at least three inches from a combustible wall. This vertical section will provide natural draft in the event of a power f ...