Heartland 3400 Operation & User’s Manual

Models: 3410 Legacy 36” Hood 900 cfm 3415 Metro 36” Hood 900 cfm 3400 Legacy 30” Hood 500 cfm 3405 Metro 30” Hood 500 cfm 3420 Legacy 42” Hood 900 cfm 3425 Metro 42” Hood 900 cfm #3936 052301 © 2001 HEARTLAND APPLIANCES INC. ® Residential Use Only READ AND SAVE THESE INSTUCTIONS INSTA ...

Parts List ............................................... 3 Technical Specifications .......................... 4 Installation Instructions .......................... 5 1. Framing ......................................... 5 A. Back Installation................. 5 B. Strip Installation ............... 5 C. To ...

Important Safety Instructions 1. Use this unit only in the manner intended by the manufac- turer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2. Before servicing or cleaning unit, switch power off at service panel and lock service disconnecting means to prevent p ...

Parts List Parts included with your unit: Canopy hood assembly Blower asssemblies-installed Adaptor with dampers Transition User’s Manual Filters (2,3, or 4 depending on hood size) Installation kit Wood strip Wire clamp connector 3/8” screws for lower installation 3/4” screws for hood installation (may not need all screws, ...

Hood Model 30” 36” 42” Power supply 120 Vac, 60 Hz same same Lighting power R20 Halogen bulbs (2) 2X50W same same Heating lamp power R38 Infrared (2) 2 X175 W same same Blower quantity 1-500 CFM 1-900 dual 1-900 dual Hood Width 30" 36" 42” Blower power 165 W 330 W 330 ...

Installation Instructions A. Back Installation 1. Locate and mark the centerline of the hood. Mark the area of the center back of the hood on the drywall. 2. Mark a rectangular opening in the drywall, 1/2" smaller than the back of the hood. 3. Cut 1/2" thick wood panel at the same dimensions as the opening. 4. Drill 7/8" di ...

C. Top Installation 1. Locate and mark the centerline of the hood. 2. Use wood panel of 1/2" thick by 12" high (see the sketch to determine width of panel). 3. Screw two 2" X 4" (thin side down) perpendicular and at the bottom of the wood panel. See sketch for location. 4. Screw a second set of 2" X 4’s angled to reach the fro ...

(fig A) 1 2 3 4 5 2. PREPARE THE INSTALLATION Parts sold separately: -Heat lamps (120V, IR 175W, PAR 38) -Backsplash (optional) -Duct (optional) Remove the installation kit from inside the hood. Make sure the following items are included: -Filters -Halogen lights (120V, 50W, PAR 20) -Wood mounting strip -Bag of parts including: ...

3. Hood Installation (3 choices depending on framing choice) A. Back Installation Note: Use only keyholes and holes shown in black, as illustrated below, and on the sketches provided. Keyholes provided for easy installa- tion. These should all be used. Optional holes provided only for stronger installation when necessary. 1. M ...

B. Strip Installation Note: Use only keyholes and holes shown in black, as illustrated below, and on the sketches provided. Keyholes provided for easy installa- tion. These should all be used. Optional holes provided only for stronger installation when necessary. 1. Install the two screws (3/4") in the wall anchors. Do not ti ...