TDK Tremor S60 Manual 

INSTRUCTIONS WATER AND MOISTURE - Keep away from water and moisture. Avoid showers, bathtubs, sinks, swimming pools, open windows, rain or wet basements. HEAT - Keep away from heat sources such as radiators, heat registers, stoves, amplifiers or similar devices. POWER SOURCES - The product should be connected to a power supply only of the typ ...

SPEAKER SYSTEM AT A GLANCE TDK Tremor multimedia speaker systems are designed to deliver high-fidelity sonic perf o rmance. The Tre m o r systems utilize breakthrough *NXT Surface Sound™ flat- panel technology, innovative tuned subwoofers and powerful amplification to deliver pure, full, richly detailed sound. The slim-profile satelli ...

1) Attach desired stands to satellites.(S-150 and S-80 only) 2) Place speakers in their desired spot. 3) Connect all speaker cables to subwoofer. 4) Connect sound source to subwoofer. 5) Plug in subwoofer to any wall outlet and switch ON. 6) Start your application and turn up the volume! SATELLITE PLACEMENT • Before connecting the wires ...

• Place subwoofer parallel and cornered near a wall. • Reflections from floors and walls help reinforce low-end frequencies. • If floor placement is not feasible, place on a table or desktop. Locate the subwoofer as close to the rear wall as possible. REMEMBER: Experiment with p ...

• Place subwoofer parallel and cornered near a wall. • Reflections from floors and walls help reinforce low-end frequencies. • If floor placement is not feasible, place on a table or desktop. Locate the subwoofer as close to the rear wall as possible. REMEMBER: Experiment with p ...

MULTIMEDIA SOUND SYSTEM TO AN AUDIO SOUR CE 1) Make sure the computer or audio source is turned off. 2) Turn down all volume controls before you start. 3) Connect the brown mini-plug from the right satellite to the R OUT on the subwoofer. 4) Connect the brown mini-plug from the left satellite to the L OUT on the subwoofer. 5) Connect t ...

or other component that uses RCA jacks, use a mini-plug - to - RCA “Y” cable. (not included) 7) Plug the subwoofer’s power cord into an available outlet or power strip and push the power switch ON. (S-60 model will automatically turn on) CONTROLS 1) Volume control: Adjusts the volume of the entire syste ...

a working AC outlet. • Check that the power is turned on. • Check that all cables are connected properly. • If connected to a computer, verify that the sound card is properly installed and functioning with the computer volume turned up. ONE OR BOTH SPEAKERS HAVE NO SOUND OR LOW S ...