HP D7171A - NetServer - LPr Manual 

'"&#&(&' Printed in March 1999 HP NetServer LXr 8000 PCI Card Installation and Replacement and Hot-Plug Operations (revised March 1999) (this addendum replaces Chapter 6 of the HP NetServer LXr 8000 Installation Guide, October 1998) ...

Hewlett-Packard makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be liable for errors contained herein or for incidental o ...

1 Introduction This chapter describes how to install I/O accessory boards into the HP NetServer LXr 8000’s I/O baseboard. The LXr 8000 supports ten PCI board slots and one ISA board s ...

2 Boot Priority This section details the NetServer’s boot order by highest to lowest priority. See Figure 6-1 and the boot order list on the following page. 10 9 8 7 6 5 4 3 2 1 Slots ...

3 By default the NetServer searches for boot devices in this order: 1. IDE CD-ROM drive 2. Flexible (Floppy) disk drive 3. PCI Slot P1 4. SCSI A bus ◊ SCSI device ID 0 ◊ SCSI device ...

4 I/O Baseboard All accessory boards plug into the I/O baseboard at the rear of the server’s chassis. The I/O Baseboard supports the following accessory board types in the respective ...

5 Remote Control Card The HP TopTools Remote Control card must be in slot 2 and requires a cable connection to I/O baseboard. The TopTools Remote Control cable connects to the I2C conne ...

6 Installation for Non-Hot-Plug Boards Use this procedure to install all accessory boards, including PCI boards, for all of the following situations: • All new accessory boards (slots ...

7 5. At the front of the NetServer, extend the anti-tip foot out of the installation rack. See Figure 6-3. 6. Remove the bezel from the front of the NetServer. 7. Use a T-25 screwdriver ...

8 9. Determine which covers to remove from the NetServer. ◊ If installing a board in slots P7-P10 only, lift off the hot-plug access panel covering these slots. See Figure 6-4. ◊ If ...