HP D7171A - NetServer - LPr Reference Manual

Hewlett-Packard makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be liable for errors contained herein or for incidental o ...

Front Panel Controls Power On/Off Switch Reset Switch Drive Activity LED Drive Error LED Fan Failure LED Over-temperature LED Floppy Disk Drive Hot Swap Drive Shelf SCSI ID #0 Hot Swap Drive Shelf SCSI ID #1 CD-ROM Drive Power ON/OFF LED Power ON/OFF Switch Power ON/OFF LED Drive Activity LED Drive Error LED Reset Sw ...

Power Inlet Network (PCI slot 4) Management Port Ultra SCSI Monitor Keyboard Mouse Parallel Port Serial Port A Serial Port B PCI slot 1 PCI slot 3 PCI slot 2 Link LED Activitity LED 100 mbps LED Indicator Definition Link LED This LED goes on to indicate that both the network adapter in the LPr and the network swit ...

NetServer LPr ships with at least 64 MB of main memory and supports up to 1 GB. Memory is available in the following DIMM capacities: 64, 128, and 256 MB. There are four DIMM sockets on the system board. DIMMs may be installed in any combination i ...

By default, the HP NetServer searches for bootable devices in the order shown below. CD-ROM Drive • Floppy Disk Drive • Embedded SCSI Controller, starting with SCSI ID 0 • PCI Slots in the order 3, 2, and 1 On each controller, the server scans for a boot device starting at device ID 0 and works up from there. The controller is al ...

Refer to the Top Tools Administration Guide for Remote Control along with the upgrade kit documentation for information on the remote control card. IPMI/ I C Connector 2 Route cable through open spaces to PCI area. DO NOT route the cable over the top of sheet metal walls. HP NetRAID Card NOTE If there are other SCSI controllers on the P ...

secondary slots. Secondary Processor Module Slot Primary Processor Module Secondary Processor VRM Slot Primary Processor VRM CPU Processor Switch NOTE: Only the first 4 switche ...

* This part is not on an exploded view. Fig Description Replacement Exchange 1 Top Cover 5064-7036 2 I/O ("Riser") Board D6129-63000 D6129-69000 3 Fan pack 5064-5858 4 SCSI backplane D6021-63030 5 SCSI management board D6021-63031 6 Hot-swappable SCSI drive Hot-swappable drive kit orderable as accessories 7 Hot-swap bay filler panel ...