HP D7171A - NetServer - LPr Installation Manual

without notice. Hewlett-Packard makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be liable for errors contained herein or for incidental or c ...

2. Verify Contents 3. Obtain HP Navigator CD-ROM Release History 4. Connect Monitor, Keyboard, and Mouse 5. Prepare for Installation 6. Remove the Covers 7. Install Additional Memory 8. Install All Accessory Boards 9. Install Additional Mass Storage Devices 10. Replace All Covers and Connect All Cables 11. Verify Ins ...

system (NOS) manufacturer to access the necessary Internet, BBS, or CompuServe site containing the drivers and software. ...

! ! ! Use only HP DIMMs listed on the Technical Reference Label located inside the HP NetServer top cover, in Information Assistant, or on Order Assistant. DIMMs can be 32 MB, 64 MB, or 128 MB in any combination. DIMMs can be installed in any order in any of the four DIMM sockets. 1. Remove the system board: 2. Install the DIMMs: 3. ...

dictates the SCSI device's boot priority and is set by jumpers located on the device, usually on the underside. Switches on the back of the hot swap subsystem set its SCSI addresses, as shown at near right. The table to the far right shows typi ...

Configure the HP NetServer Verify Installed Accessories (Optional) Replace All Covers and Connect All Cables 12 13 11 2. Run Configuration Assistant and Installation Assistant: Go to the HP Navigator Main Menu. If you want to change the language, select "Set Preferences" and the language. Select "Configuration and Installation Assi ...