Sound Performance Lab 9844 Manual 

Text of the manual

By Hermann Gier and Wolfgang Aichholz

Version 1.4 - 5/2000 The information in this document has been carefully verified and is assumed to be correct. However Sound Performance Lab (SPL) reserves the right to modify the product described in this manual at any time.Changes without notice.This document is the property of SPL and may not be copied or reproduced

The GoldMike is another jewel in the SPL Tube series. Like all SPL

tube processors,the GoldMike combines the unique sonic qualities of tube technology with state-of-the-art manufacturing, meti- culous component selection and high-tech conception. This latest product, a dual-channel tube microphone preamplifier with superb sonic qualities, is particularly s

Carefully select a place for setting up the GoldMike. The unit

should be situated away from heat sources and direct sunlight. Avoid installing your GoldMike in environments exposed to vibra- tions, dust, heat, cold or moisture. Keep the unit away from trans- formers or motors or any other unit that could generate large variations in power supply or cause e

The following graph shows the correct wiring for connecting un-

balanced signals to the balanced XLR connectors. VERY IMPORTANT Phantom power must be switched off before unbalanced signals are connected! Otherwise short circuits cause damages! Built around a torroidal transformer,the power supply allows for a minimal electromagnetic field with no hum or me

Advantages of the SPL dual-stage preamplifier

The GoldMike's engine is the newly designed SPL dual-stage preamplifier. During the first stage of amplification the signal is amplified by a semi-conductor circuit while the second stage applies tube electronics.We achieve a high common-mode-rejec- tion by using laser trimmed components. Likewise, minimal nois

Sound optimization already during recording:

FLAIR circuitry The FLAIR circuitry enhances the presence of vocals and acoustic instruments, FLAIR makes these elements cut better through a mix. It has proved to be superior in double-blind tests. Once a signal completes the semi-conductor amplification stage, it is then split and fed into the tube stage and t

The MIC GAIN knob controls the input signal's amplification. The

range extends to 72 dB of gain.The levels should be adjusted for a meter reading around 0 VU to get the best signal-to-noise perfor- mance. Please note that the meters show only an rms/average level, so keep your GoldMike from pegging the meters' needles. When adjusting the M

Other Amplifier Manuals