HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual

Including 6.5 August 25, 2003 Objective The intent of this document is to provide you with key information required for completing the installation of NetWare on an HP Server (HP Server series or HP Netserver series). Installation requires familiarity with both DOS and NetWare. Please refer to Novell's NetWare Inst ...

Installing NetWare on your network server requires two major steps: Step 1: Preparing the bootable devices (creating a DOS partition, formatting the partition, installing DOS, and connect the system to a CD-ROM drive.) Step 2: Install NetWare and the appropriate HP NetServer mass-storage drivers. Section 2. Aut ...

of the screen, and then select Diskette Library. 4. Select the desired driver. Once the desired driver is highlighted, insert a blank formatted 1.44 MB floppy diskette into the floppy drive and select Create Diskette(s). (Manual installation requires NOS Drivers diskette). 5 ...

8. Use the edit utility to add the following lines to your CONFIG.SYS file: DEVICE=C:\directoryname\FDATACD.SYS /D:driver1 Where directoryname is the path to the directory containing the FDATACD.SYS driver, and driver1 specifies the driver signature name of the first CD-ROM device driver. The driver signature name ...

3. Create a directory named NWUPDATE. 4. Copy all drivers from the NOS Drivers disk to the NWUPDATE directory. NOTE: If you desire to use HP NetRAID series adapters in I20 mode, ensure the appropriate drivers have been created from the HP NetServer Navigator CD-ROM and copy them to the NWUPDATE directory you created and omi ...

Install found the following hardware but found more than one driver supporting this hardware: xxx.xxxx.xxxx.xxx.xxx Press to continue without selecting. The installation program for NetWare should load all drivers placed in the NWUPDATE directory and match appropriate drivers to the hardware. When the process ...

repeat steps 18 through 26 until all devices are partitioned. 24. After all devices are partitioned press F10 and select continue with installation from the Disk Partition and Mirroring Options. NOTE: Press Enter through any messages you may receive. 25. If you wish to modify any ...

installation issues. After completing the installation of Netware 4.2, you must install the latest support pack from Novell. This can be downloaded from: http://support.novell.com Installing the SMP driver MPS14.PSM for Netware 4.2 The Netware 4.2 installation program no longer auto- ...

server 5. Use the NetWare install utility to create the necessary partitions and volumes. Also load the NetRAID I2O compatibility driver, mril4_xx.ham, if: - An HP NetRAID (D4943A) or HP NetRAID-1 (D4992A) is present in the system (do not use the mega4_xx.ham driver in thi ...

5. After reading the License Agreement, highlight Accept License Agreement and press Enter. 6. Highlight Continue with Existing Partition and press Enter. For Small Business Suite 5/5.1 7. When prompted to Create or keep a DOS Partition select Continue with existing partition and click Next. 8. Click Yes to any warnings and Next to reboot and ...