Speco PL200M Operation & User’s Manual
Text of Speco PL200M Operation & User’s Manual
Speco PL200M 5x4 Multi Source/Multi Zone Matrix Distribution P A Amplifier
Speco Technologies
200 New Highway • Amityville, NY 11701
For more information on our products go to:
www.specotech.com or contact us at: 1-800-645-5516
Speco PL200M Please read this manual carefully before operating
this unit for the first time.
All rights reserved to Speco Technologies. All features and content might be
changed without prior notice. Any photocopy, translation, or reproduction of
part of this manual without written permission is forbidden.
SAFETY RELATED SYMBOLS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol, wherever used, alerts
you to the presence of un-insulated
and dangerous voltages within the
product enclosure. These are voltages
that may be sufficient to constitute the
risk of electric shock or death.
WARNING
Describes precautions that should be
observed to prevent the possibility of
death or injury to the user.
Describes precautions that should be
observed to prevent damage
Do not install this product near any direct
heat source. Do not block areas of
ventilation as doing so could result in fire.
Keep product away from open flames.
IMPORTANT SAFETY INSTRUCTIONS
Read these instructions
Follow all instructions
Keep these instructions. Do not discard.
Heed all warnings.
Only use attachments/accessories
specified by the manufacturer.
Power Cord and Plug
Do not tamper with the power cord or plug.
These are designed for your safety
19. AC Voltage Selector
20.Monitor Line Out
21.Monitor 1W8
22."Priority" Terminal.
When these terminals are short-circuited (i.e. By means
of using an electrical switch), the audio signals coming from "CH4", "CH5", are
attenuated while the signals coming from"CH1", "CH2","CH3" are gaining
priority.
23.Input "AUX Paging"
24. a. Zone
25.''LINE IN" inputs
19
20 21 22
23
24
25
5
Connecting the speakers with 70V output
0
1. Gain knob
2. High knob
This is the treble control. You can use it to get rid of high frequency
noises or to boost the sound of cymbals or the high harmonics of
the human voice. The gain range goes from -10dB to 10dB with the
central frequency 10kHz.
3.Low knob
This is the Bass control. Boost male voice or kickdrum and bass guitar. Your
system will sound much bigger than what it is. The gain range goes from -10dB
to +10dB and th
11. Zone1 VOLUME
VOLUME controls the output signal level of ZONE1.
12.LED VU-meter
This stereo 6 segment LED-meter indicates the level of the
overall output signal.
13.MONITOR selector
14. PL
This LED is the power indicator. When the amplifier is powered on, this LED
lights up. When the amplifier is powered off, this LED lights off.
15. Power switch
When the switch is set in the position ON, the unit is powered
on.
26.The mono MIC/LINE channels
27. Ch1, CH2, CH3 and inputs sensitivity and XLR phantom switch
28.Line Out Bal/Unbal
29.Power Amp Output
27
28
29
6
Total impedance: 4 ohms
+
70V
25V
COM
4
-
G
8
+
70V
25V
COM
4
-
G
8
Connecting the speakers with 25V output
0 0 0
+
70V
25V
COM
4
-
G
8
25V
25V
25V
7
Total impedance: 8 ohms
The channels are numbered from 1 to 4. You can connect
balanced, low impedan