Whirlpool 4B74966B Installation Instructions Manual

these instructions. IMPORTANT: Installer: Leave lnstallcrtion Instructions with the appliance. Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for local inspector’s use. Part No. 4B74966B/4358149 Rev, C Microwave Hood Combination ...

Proper installation is the installer’s responsibility. A qualified technician should install this microwave oven. Make sure you have everything necessary for proper installation. It is the responsibility of the installer to comply with the installation clearances specified either on the serial/ ratina blateor in the Installation Instru ...

aboliance. Electrical Shock Hazard l Electrical ground is required on this appliance. l If cold water pipe is interrupted by plastic, non-metallic gaskets or other insulating materials, Do Not use for grounding. l Do Not ground to a gas pipe. l Do Not modify the power supply cord plug. If it doe ...

wrtn the blower assembled for .roof-venting installation, Adjustments must be made for wall-venting and ventless installation, Follow the instructions for preparing your microwave oven for the type of venting method you need. For all installations: II grille 1 a Remove the three screws from the grille on the top front of the mi ...

-.m lake special care when drilling holes into the wall. Electrical wires may be concealed behind the wall covering and contact with them could resuli in electrical shock. uppercablnet template m t--------7 m L.,,---- J 0) ‘0 f ----“1 O0 L-m -e-m I 000000000000 0 00000000000 0 wall template 8 n Drill a l/2” hole for the mo ...

recessed 3/4” or more, align 2” x 2” filler blocks of required thickness (not included) with the shaded squares marked “N’ and “P’ on the upper- cabinet template. Mark the cut-out position on the filler blocks through the upper-cabinet holes “L’ and “M’. Drill 3/B” diameter hole at the marks on filler bloc ...

does not operate... C;heCk that the circuit breaker IS not tripped or the house fuse blown. Check that the power supply cord is plugged into the wall receptacle. If you need assistance. I Inseti the tab end of filter screen into the opening and slide entire screen toward the back of the microwave oven until screen is securely in positior, R ...