HP NetStorage 6000 Installation Manual
Text of the manual
HP NetStorage 6000
NOTE: Installation may take from 15 minutes to 2 hours, depending on
the amount of system configuration you require.
H
P
N
E
T
S
T
O
R
A
G
E
6
0
0
0
Gather Information
Record the following information if you are not
using DHCP:
IP Address
Subnet Mask
Gateway Address
Check Contents
WARNING: The unit is heavy. Have someone
hel
Place the Unit in a Rack (optional)
NOTE: The unit comes with two sets
of rack mounting hardware. Use the set
that works best with your rack. To mount
the unit, you will need the following
tools:
• Flathead screwdriver
• 11/32" wrench
• Torx-25 screwdriver (HP racks)
• Phillips screwdriver (Rittal racks)
A. Adjust the rail assemblies to fit the
depth
Connect the Unit
A. Connect a network cable to the network interface card (NIC) port.
B. Remove the protective cap from the primary and secondary
sockets on the back of the unit. Connect both power cables.
NOTE: Although the unit can operate with only the primary socket
connected, using only one power cable will generate an error.
C. Power on the unit.
D.
Pr
Use a Web Browser to Configure
Network Settings
A. Using a computer on the network, open a web browser and
type the unit’s IP address in the address or location field.
You will need to use Internet Explorer 4.01 or later, or
Netscape 4.51 or later. If you have trouble connecting, try
enabling the option to bypass the proxy server for local
addresses.
NOTE:
Build the Storage System
Attach a Backup Tape Device (optional)
A. Shut down and power off the HP NetStorage 6000.
B. Connect the SCSI jumper cable to the tape device and
attach the terminator.
C. Connect the SCSI interface cable to the HP NetStorage 6000
and to the tape device.
D. Connect the power cable to the storage device, and plug it into
a grounded ou
