HP DESIGNJET 3D Manual 

Introductory Information HP Designjet 3D Removal System Informations d’introduction HP Designjet 3D Removal System Einführende Informationen HP Designjet 3D Removal System Informazioni introduttive HP Designjet 3D Removal System Información de introducción CQ658-90006 CQ658-90006 ...

A complete user guide to your system is available on the web (http://www.hp.com/go/3dprinter/ knowledgecenter). The user guide provides information on the following topics: • Unpacking, inspecting and installing • Warranty information • Understanding the system • Control Functions • Maintainin ...

with a specific amount of cleaning agent bags added to the cleaning agent receptacle. The system heats and circulates solution around the models in the cleaning tank. The solution dissolves the support material without harming the underlying model ma ...

2 Full cleaning tank level LED 3 Half cleaning tank level LED 4 Cycle length button 5 Long cycle length LED. 6 Medium cycle length LED. 7 Short cycle length LED. 8 Progress LEDs 9 Process error LED 10 Start cycle button 11 Cancel button 1 2 6 3 8 9 7 10 5 4 11 ...

been successfully completed. Also, make sure all the steps have been correctly followed as described in the HP Designjet 3D Removal System Assembly Instructions. Consult your area's requirements regarding the disposal of the HP Designjet 3D Remo ...

model bag, always select the lower lid position and do not add other models to the model basket. • Delicate models have features with a cross sectional areas under 19 sq. mm (0.03 sq. in.). • Flat models have large flat areas that are greater than 64 mm x ...

agent receptacle. A. Dry hands before opening the cleaning agent bag. B. Open the cleaning agent bag as shown. C. Empty all the contents of the specified number of cleaning agent bags into the cleaning agent receptacle (see Table 1). D. Avoid handling the ...

Progress LEDs. When the cleaning cycle is started, all the progress LEDs are illuminated in yellow. Each progress LED from right to left will turn off as the cycle time progresses. When the cleaning cycle is complete, the left-hand progress LED will turn from yell ...

Problem Recommendation No power Verify that the power cord is securely plugged in. Verify that the power switch is in the ON position. Verify that AC power is present at the power outlet. Water has not fully drained from the clean- ing tank Verify that the strainer and cleaning tank drain are not clogged. Verify that ...

error LED with cycle length LEDs as shown: Verify that the drain hose is not clogged. Verify that there are no kinks in the drain hoses. Make sure the system is at least 20 cm (8 in.) above the drain hose dis- charge. Make sure that no section of the drain hose is higher than the drain hose discharge. Power cycle the ON/Off switch at t ...