HP MSM710 Installation Manual

Text of HP MSM710 Installation Manual

HP MSM710 Controllers Installation Guide

Abstract This document describes how to install and initially configure the MSM710 Controllers. This information applies to the MSM710 Access Controller (J9328A) and the MSM710 Mobility Controller (J9325A). These products are hereafter referred to as controller. See also the MSM7xx Controllers Configuration Guide. HP Part Number: 5998-1423 Published: December 2011 Edition: 1

© Copyright 2011 Hewlett-Packard Development Company, L.P.

The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. Acknowledgments Microsoft®

1 Preparing for installation.............................................................................4

Package contents......................................................................................................................4 Identifying controller components................................................................................................4 Important installation prerequisites.........................................

1 Preparing for installation

Package contents • Controller • Power supply • Self-adhesive rubber feet • Documentation Identifying controller components The following figures show the various controls and connectors on the controller. 1 2 3 4 5 Controller rear panel 4: Internet port 1: Power 5: Console port 2: Reset button 3: LAN port 1 3 2 Controller front panel 1: Power LED 2: LAN port LED 3: Internet port LED LAN port and Internet port The contro

The controller console port is a standard serial port with DB-9 connector. To connect to a computer,

use a standard (straight-through) serial cable (male-to-female). For pin-out details, see the MSM7xx Controllers Configuration Guide. Table 1 LEDs Description State LED The controller has no power. Off Power The controller is starting up. If the power LED continues to blink for several Blinking minutes, it indicates that the software failed Bli

This product does not have a power switch. It is powered-on when the LAN port is connected

to the external power supply is plugged into a PoE power source. • This product and all interconnected equipment must be installed indoors within the same building (except for outdoor models), including all PoE-powered network connections as described by Environment A of the IEEE 802.3af standard. Powering the controller The controller can be powered by: • Th

This is a general procedure. It is the installer’s responsibility to perform the installation

in accordance with local electrical code and regulations. It is recommended that you mount the controller only after performing the procedures in this guide and familiarizing yourself with the product. • For table-top installations, attach the rubber feet to the bottom corners. • For rack or wall mounting, you can order the optional par

3 Controller initial configuration

This procedure describes how to perform the initial configuration of a factory-default controller, enabling you to establish a wired connection through the controller to the Internet. The controller is managed via its Web-based management tool using Microsoft Internet Explorer 8+ or Mozilla Firefox 3+. Perform initial configuration NOTE: Because the provided power supply is the recommended way of powering the controller,

Follow the Configure initial controller settings workflow.

a. It is highly recommended that you follow the Configure initial controller settings workflow. This workflow is selected by default. Select Start to launch this workflow. If you choose not to run a workflow at this time, select the Home button to exit the workflow page. b. The Configure initial controller settings workflow provides instructions and prompts you for options. Read the instructions

Review the settings before you select Apply to save and activate the new configuration

on the controller. Alternatively, select Back to go to the previous workflow page or select Cancel to discard your workflow settings and exit the workflow. d. After applying your changes, a confirmation page appears showing the menu paths to each configuration page associated with the Configure initial controller settings workflow. For example: e. If desired, select a pa

HP Recording Equipment Owners Instructions: