Vivotek IP8372 Operation & User’s Manual

Cable Management Rev. 1.1 ...

Table of Contents Overview������������������������������������������������������������������������������������������������������� ...

Electromagnetic Compatibility (EMC)���������������������������������������������������������������������������������������������������� ...

Overview VIVOTEK IP8372 is a professional bullet camera offering 5-Megapixel or 1080p Full HD resolution with superb image quality up to 30 fps. Featuring 5-Megapixel resolution and high- performance H.264/MPEG-4/MJPEG compression technology, the IP8372 offers extra-smooth video and wide coverage. The IP8372 employs many advanced fe ...

Read Before Use The use of surveillance devices may be prohibited by law in your country. The Network Camera is not only a high-performance web-ready camera but can also be part of a flexible surveillance system. It is the user’s responsibility to ensure that the operation of such devices is legal before installing this unit for i ...

Physical Description IR LED Lens Light Sensor NTSC-PAL switch General I/O Terminal Block Reset Button Auto Focus Button SD/SDHC/SDXC Card Slot NTSC PAL Status LED The LED indicates the status of the Network Camera. Item LED status Description 1 Steady Red Power on and system booting Red LED off Power off 2 Blink Red every 0.15 sec. ...

DI/DO Diagram Please refer to the following illustration for the connection method. 12V +12V Digital output PIN 1 Power+12V PIN 2 Digital input PIN 3 or 5 Ground PIN 4 or 6 Gnd Camera Power Input Output 4 1 5 or 6 2 +30 VDC Max. VDC Switch Relay BJT transistor Gnd Camera Power Input Output 4 1 5 or 6 2 +12 VDC VDC Switch Relay BJT t ...

Hardware Reset The reset button is used to reset the system or restore the factory default settings. Sometimes resetting the system can return the camera to normal operation. If the system problems remain after reset, restore the factory settings and install again. Reset: Press and release the recessed reset button. Wait for the Net ...

Installation Hardware Installation 1. Attach the alignment sticker to the wall. Drill four holes into the wall. Then hammer the supplied plastic anchors into the holes and secure the plate with supplied screws. 2. Fix the intersection bracket to the side of the Network Camera with two screws. 3. Feed the RJ45 cable through the front ...

Waterproof Connector 1 DO+ (12V) 2 Digital Output 3 Digital Input 1 4 Ground 5 Digital Input 2 6 Ground 7 TV Out + 8 TV Out - 1J3 J6 1 8 1 8 Components of the Waterproof Connector Seals (C) Housing (D) Sealing Nut (E) Seal (B) Screw Nut (A) Pin Definitions J3 1 Ext. MIC 2 Audio Ground 3 Audio Line out 4 Audio Ground 5 Ground 6 DC 1 ...