Star Trac E-TRx Work Instructions

Text of the manual

620-7920 Rev A

STAR TRAC 14410 Myford Road Irvine, CA 926060 USA WORK INSTRUCTIONS, E-TRx / E-TRxe INSTALLATION

620-7920 Rev A

GENERAL Before using this product, it is essential to read ALL installation Instructions and this ENTIRE operations manual; the manual describes equipment setup and instructs members on how to use it correctly and safely. 1. Hex (Allen) key, 1/4” (Included) 2. Hex (Allen) key, 5/32” (Included) 3. Screwdriver (blade-tip), 3/32” (Includ

620-7920 Rev A

Step 3. Remove the side box. Step 4. Lay all boxes on the floor and verify that all components are included (see next page for details). Step 2. Remove the top cover. Step 1. Lay the unit in the area where it is going to be assembled and remove the straps. UNPACKING INSTRUCTIONS

620-7920 Rev A

Step 7. Verify components in box two (continued): 1.Neck cover. 2.Display console’s top back cover (p/n 020-7074). 3.Neck grommet. 4.Power cable. 5.Owner’s manual with warranty registration card. 6.Hardware kit. Step 8. Verify components in box two (continued): • Display console’s upper back cover (p/n 020-7069). • Display console

620-7920 Rev A

Step 9. Verify the following tools are included in the hardware kit : Step 10. Verify hardware included in the hardware kit: Step 12. With a helper, lift the treadmill frame assembly from the shipping crate platform and place it in the location where it will be used. Make sure the unit is placed near a power outlet. Caution: The motor shrou

620-7920 Rev A

Step 3. Position neck close to the service opening in the front of treadmill so the cables go into the opening first. Step 4. Route all cables from neck into motor compart- ment through lower neck service opening. Caution: Make sure not to pinch any cables. Step 2. Remove the neck form shipping box and verify the cables are properly fed thr

620-7920 Rev A

Step 6. Align the front holes and fasten with (2) 5/16-18 x 3.0”, (2) 5/16 washers and (2) lock washers. DO NOT fully tighten yet. Step 5. Insert neck into place, then align the top holes. Using the 1/4” Hex key, fasten the neck to the frame with (2) 5/16-18 x 1.0” socket head screws, (2) 5/16 washers and (2) lock washers. DO NOT full

620-7920 Rev A

Step 10. Now install the top display rail. Align the rail’s mounting holes with the neck holes. Note: If the electronic display console was assembled to the rail; remove the screws holding it to the rail and store the display for later use. Hint: If one person is assembling the unit, insert two 5/16 screws into top rail holes and use the

620-7920 Rev A

Step 15. Now tighten the 2 front neck screws (5/16-18 x 3.0” socket head) to a torque value of 200 in- lbs (22.5 Nm). Step 14. Make sure the gap between the rails is closed and, using the 5/32” Hex key, fasten the (2) #10 button head socket screws. Tighten the screws to a a torque value of 45 in-lbs (5.0 Nm). Repeat for the other sid

Other Treadmill Manuals